Question about 2006 Ford F-150

1 Answer

I have no power on a/c control ford f 150 2007

Posted by on

  • Steve S
    Steve S May 11, 2010

    Did you check the fuses ? Is this just the AC that does not work, or the HVAC in general ? Is the panel dead ? Have you had any work done to the truck as of late ( new head unit, etc ) ?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

The A/C is ran threw the transmission computer are you having problems with it shifting funny? if so check all fuse in the inside of the truck then check the fuses in the engine compartment, if you don't find any blown fuses buy a AC connector and hook up one wire to ground on the battery and one to positive on the battery se if the clutch kicks in if it does try starting it and see if it gets cold if it does then it's the AC computer that has a problem like a pinched wire between the pan and transmission. Do not run a hot wire to the AC connector be sure to purchase one so you don't blow the transmission computer it costs $300 plus labor. it it does not run then pull the low pressure switch plug on the receiver dryer looks like a aluminum tank insert a paper clip into the plug then try it again if the ac comes on and cools then you have a bad pressure switch, it costs $10.00 and can be replaced without losing refrigerant then unhook your spare power connector and hook up the original hook up to the compressor and replace the low pressure switch it should work then. If it does not work get back to me and I will give you some other tests to check it with.

Posted on Feb 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Good morning on my ford 150,2007 fuse #111# keeps blowing when i switch to 4wd

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Dec 19, 2016 | Ford Cars & Trucks

1 Answer

2010 ford fusion hyprid power steering went out

Power Steering - Hybrid The electric power assist steering system consists of:
  • power steering control module
  • electric motor
  • torque sensor
  • rack-and-pinion steering gear
The electric power steering system provides power steering assist to the driver by replacing the conventional hydraulic valve system with an electric motor coupled to the steering gear. The motor is controlled by an electronic control unit that senses the steering effort through the use of a torque sensor mounted between the steering column shaft and the steering gear. Steering assist is provided in proportion to the steering input effort and vehicle speed.

your best bet would be to have the ford dealer check it out !

Dec 02, 2016 | 2010 Ford Fusion Hybrid

1 Answer

1997 Ford F-150 Reg Cab, V-6 Keep blowing fuse #24,Power Box under hood,30 amp, PCM power,

Try unplugging the power control module. If the fuse still blows its wiring if it doesn't I would guess the power control module is bad.

Nov 12, 2016 | Ford F-150 Cars & Trucks

1 Answer

How to fix code p2004 on 2005 ford focus

you code is here

P2004 Ford Intake Manifold Runner Control Stuck Open Bank 1

Possible causes - Intake Manifold Runner Control (IMRC) monitor signal shorted to power
- Faulty Intake Manifold Runner Control (IMRC) actuator
- Faulty Intake Manifold Runner Control (IMRC) solenoid
- Damage Powertrain Control Module (PCM)
- Blocked vacuum hoses
alt="What does this mean?"> What does this mean? Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) P2004 Ford Description The P2004 is set when the Intake Manifold Runner Control (IMRC) is commanded closed by the Powertrain Control Module (PCM), but the IMRC indicates open.

Read more:

Sep 14, 2015 | Ford Cars & Trucks

1 Answer

2001. Where is ABS system power control relay located?

Ford is fond of placing the power control relay in the under hood fusebox, but there may be a larger problem with the ABS control module which is located on the inside of the driver side frame rail - usually just behind the driver seat.There are some models that have the relay mounted next to the control module.
Hope this helped!!

Jun 07, 2015 | Ford Expedition Cars & Trucks

1 Answer

No power to radio in my Ford pick up diesel 06 fuses seam fine

It can be faulty or shorted fuse,first test the fuse controlling radio:----
Click the link below:----

Radio Controlling Fuse Location?

Ford radio not powering ON?

Keep updated for more help.

Nov 18, 2012 | Cars & Trucks

1 Answer

Power Seat Control does not move the seat front or back

Try tapping the power seat frame with a hammer to unbind the motor .

Nov 08, 2009 | 2003 Ford Expedition

1 Answer

The electric windows on my 1993 ford taurus has stopped working from the control switch on the drivers door

check the switch for power,if its got power and does not control the windows, the switch is bad,if it has no power possbile fuse, check fuses and check the switch, replace both if needed

Oct 02, 2009 | 1993 Ford Taurus

2 Answers

2002 Ford Explorer passenger power window problem

Check the fuse panel first, after that check your fuse relays under the hood, if not then it might be a wiring problem.

Jul 30, 2009 | Ford Explorer Cars & Trucks

1 Answer

Cruise control does not work ,all fuses good 2000 ford mustang

If fuses are good, check power to the cruise control with multi-tester, voltmeter, or equivelant. If there is power, than the cruise control accumulator is shot.
If there is still no power, the switch is bad.

Jun 22, 2009 | 2000 Ford Mustang

Not finding what you are looking for?
2006 Ford F-150 Logo

553 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides