Question about 1996 Jeep Cherokee

1 Answer

Codes show all cylinders are missing .Check engine light stays on, has noticable miss at idle thru tailpipe. Scan shows all six cylinders are missing. Even shows a 307 code !

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Cap, rotor, plugs, and plug wires.

Posted on Feb 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

4 Answers

2003 Lincoln T C started with an occasional misfire. The Service Engine light flashed a short while, then stayed on for several minutes, then went off. Mechanic could find no codes. Any suggestions?

The only way a code reader works, is if the check engine light stays on continuous, There cant be anything drastic,Because light goes out. God-Bless!

Nov 11, 2017 | Lincoln Cars & Trucks

1 Answer

2003f/250 5.4 dead miss and no power

Check engine light on ? Have hooked up to a scan tool that showes mode six misfire data . makes life a heck of a lot easier . Knowing which cylinder is missing . Does your's have coil on plug ignition system ? Videos on youtube ,diagnosing misfires .

Feb 11, 2017 | Cars & Trucks

1 Answer

I have a 2007 1500 suburban - check engine light came on and started missing - code showed cylinder 1 missing - i changed spark plugs and noticed that the #1 spark plug had a piece of the ceramic broken...

cylinder 1 getting too hot causing ceremic crack could have wrong heat range plug in which spark plug too hot.or need replace spark plug plug wire could be bad best replace all spark plug wires.

Sep 08, 2013 | Chevrolet C1500 Cars & Trucks

1 Answer

Having codes P0306 and P0316 show up for 2005 Ford Taurus

Well code 306 is for a miss on cylinder six and code 316 is for a miss detected on startup, which you probably already know.
Since I assume you have replaced the ignition parts for that cylinder,
the next component to check is the injector. You may want to check fuel pressure too.

Jul 21, 2013 | 2005 Ford Taurus SE

1 Answer

2002 Chevy Cavalier misfire

You may want to check for fuel volume and fuel quality. There may be moisture in the fuel. It would also help to know which cylinders it is misfiring on. Scan tool will show the misfire on live data.

Nov 24, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

2003 Santa Fe V 6 miss firing with New plugs and wires

Got a check engine light? Get the codes read to find out if the misfires are on all cylinders or just 1. Could be ign coil, bad crank or cam sensor, or a valve issue

Jan 27, 2018 | 2003 Hyundai Santa Fe GLS

1 Answer

Missfiring detected in OLDSMOBILE intrigue 2002 3.5L

For engine misfiring problem check the help links mentioned below. Click the link below to go through the troubleshooting procedure :---- Engine misses and truck jumps? Hard to down shift? Issue with high gear only?

Bad miss at idle?

While stop engine idles like cylinder missing?

Engine Misfire codes for car?
Engine Misfire codes?

Misfire on cylinder 4?

Oil on spark plugs and car misfires?


This will help.


Jan 30, 2012 | 2002 Oldsmobile Intrigue

1 Answer

2001 porsche idles funny

If your idle is rough while idling but improoves once you are driving, I would check for vacuum leaks. Check for any loose or disconnected vacuum lines or a loose rubber bellows at the throttle body. If you have a cylinder missing you should see a check engine light on and the codes will likely show which cylinder is missing.

When was the last time the spark plugs were changed?

Feb 20, 2011 | 2001 Porsche Boxster

1 Answer

I have a miss in my 2002 gmc yukon

Have the vehicle checked for code's . will show what cylinders are missing . Do drive it like that , check engine light flashing , will damage the catalytic converters

Jan 15, 2018 | 2002 GMC Yukon Denali

1 Answer

1997 Lincoln town car - engine miss

How do you know it's not a injector ? Could have a burnt transistor or driver in the PCM - engine computer . This transistor or driver supply's a PWM -pulse width modulated ground . No code's shown so probably not that . What is the compression of all the cylinders . How are you checking for codes ? Code reader ? A professional type scan tool that can view mode 6 data would show misfire counter . would know what cylinder is misfiring . Could have a transistor (driver) for coil control that could cause a misfire ,but would be two cylinders missing . Video's on youtube showing how to test a PCM/ECM driver (transistor)
How to test computer transistor driver without scan tool

Nov 03, 2017 | 1997 Lincoln Town Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides