Question about 2006 Hyundai Santa Fe
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?
Posted on Oct 28, 2008
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
Posted on Apr 06, 2009
Most likely the o-ring seal between the torque converter and the transmission is going bad. Get that transmission rebuilt pronto before serious damage is done! But first, have a mechanic drop the transmission pan and look for signs of a very thin silvery film coating the inside of the pan. If found, then the transmission definitely will have to be rebuilt, and the torque converter will also have to be replaced since embedded metallic particles in the old torque converter will eventually come loose, due to wear of the clutch plates within the torque converter, and eat up the rebuilt transmission. Now, here is the deal once the transmission has been rebuilt:
Change the transmission fluid and filter once a year -- no matter what! If you do this, then you should never have any more problems with the transmission.
Posted on Apr 20, 2009
This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.
Posted on May 22, 2009
Tips for a great answer:
Jun 02, 2017 | Hyundai Cars & Trucks
on Oct 24, 2013 | Hyundai Cars & Trucks
Aug 02, 2010 | 2004 Hyundai Santa Fe
Mar 04, 2010 | 2005 Hyundai Santa Fe
Jan 20, 2010 | 2003 Hyundai Santa Fe
Aug 08, 2009 | 2004 Hyundai Santa Fe
Apr 17, 2009 | 2003 Hyundai Santa Fe
Mar 22, 2009 | 2004 Hyundai Santa Fe
Mar 19, 2009 | 2003 Hyundai Santa Fe
63 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: