Question about 1999 Land Rover Range Rover

2 Answers

Can you tell me the torque settings on a rocker shaft 4.0 petrol and a 4.6 range rover 98-99

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Steve posted the specs for the rocker cover. The rocker arm torque spec is 38nm, or 28 ft.lbs.

Posted on Feb 11, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 1,675 Answers

On the 4.0 its , first tightning 3nm, second tightning 7nm and its the same for the 4.6 hope that helps

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 P38 HSE Range Rover 4.6l on petrol and LPG. It stopped whilst driving and I can't get it started. Had a guy look at it with a diagnostic tool and he said it came up as a crank failure.


the crank/cam sensor will show as a failure if the timing belt. chain has broken
check for that first by removing the oil filler cap and see if the rockers are moving

Jan 01, 2017 | Rover Cars & Trucks

1 Answer

Practically,how many ways are Nissan Pathfinders jeep,similar,or parallel to Range rover, especially the 98,99,or the year 2000 model,or specifications?


Not sure what model of jeep your comparing as the Grand Cherokee is a uni-frame while the pathfinder (that generation) is a body-on-frame.

Jun 01, 2015 | Nissan Cars & Trucks

1 Answer

Why is my LAND ROVER RANGE ROVER 4.0SE AUTO PETROL/ LPG GAS


Because a previous owner (or the dealer) wanted the lower cost of running on LPG using a dual fuel system so petrol (gasoline) could be used too. If the work was done professionally it provides the best of both but the downside is the reduction of usable space in the load space. You will find more about this in the "articles" page at http://www.graemecooper.com.au

Aug 12, 2014 | Land Rover Cars & Trucks

1 Answer

Torque settings for rocker shaft for a 1998 7k toyota 1800


There is no such thing as a rocker shaft. There is a cam shaft, rocker arm assembly, Rocker arm, lifter etc. If you are talking about the rocker arm assembly that bolts to the head, it is 58 Ft/lbs. If you are talking about the actual rocker arms, you tighten them till they contact the push rod and the valve stem and then you put oil control clips on so the oil does not spray and you start the engine. You tighten them down till the chattering noise goes away, then back them off 1/8 to 1/4 turn.

Apr 25, 2014 | 1995 Toyota Corolla

1 Answer

1989 range rover not pumping petrol 3,9 runs on gas but will not pump petrol


Hi there, did you run the petrol low or out, the fuel pump will keep pumping while the key is on and if your running on gas them it's still running, I would say the fuel pump has failed due to no lubrication from fuel, be sure to keep your petrol tank at least at 1/4 of tank full

Mar 06, 2014 | Cars & Trucks

1 Answer

Back firing through air intake at 3000-4000 revs


IF the engine runs fine at lower RPM and there is no fault codes appearing then it may be valve bounce from weak /broken valve springs or incorrect tappet clearance or hydraulic tappets that are badly worn and not operating at the high RPM. Check rocker shaft bushes and rockers for wear that will allow the units to fail at RPM. Another thing --if you have points in a distributor then the points may be bouncing from weak spring or the cam for the pionts is badly worn on a worn distributor shaft.

Nov 16, 2013 | 1988 Land Rover Range Rover

1 Answer

Torque setting for 1972 Cororna


My manual shows an 8RC for 70 and 71 and an 18RC for the 72-74

18RC valve clearance HOT IN .008 EX .014 cold spec. .007 .013
Cyl head 72-82 Ft Lbs
Rocker caps 12-17 ft lbs
cam bearing clearance .001-.002
cam endplay .0017-.0066
oil tube 11-16 Ft Lbs

Jun 15, 2013 | Cars & Trucks

2 Answers

I have a noise tappet on my range rover v8 how can i stop it


The tappets are worn out! so they can not fill with the oil to eliminate the clearance between the tappet and the rocker arm! change them!

Sep 14, 2009 | 1993 Land Rover Range Rover County

1 Answer

How to adjust rocker shaft on discovery td5


There are adjustment screws on the rockets according to RAVE.
The procedure is as follows:
1) Rotate the engine clockwise until No 1 injector lobe is at full lift.
2) Rotate rocker adjusting screw clockwise until the injector plunger is felt to bottom out.
3) Rotate rocket adjusting screw anti-clockwise one complete turn to give plunger the required bump clearance and tighten rocker arm adjusting screw locknut to 16Nm. Ensure the screw does not turn as the locknut is tightened.
4) Carry out the procedure for the remaining 4 rocker arms.
5) After completion of rocker arm adjustment slowly rotate engine clockwise 2 complete turns by hand to ensure that no injectors are bottoming out on their plungers.

Apr 08, 2009 | 2003 Land Rover Discovery

1 Answer

2001 saturn sc2 rocker arm suspected


Rocker arm shaft to head torque is 19Ft-lbs

Oct 13, 2008 | 1992 Saturn SL1

Not finding what you are looking for?
1999 Land Rover Range Rover Logo

568 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...