Question about 1998 Ford Explorer

1 Answer

The hand break for my 1998 fird explorer wont work..what can i do?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Tighten the cable, check e brake pads.

Posted on Feb 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 ford explorer cranks wont fire


Check your Cam,MAP,MAF sensors.

Mar 07, 2012 | 1998 Ford Explorer

1 Answer

Can't get door panel off a 1998 ford explorer suv


The arm rest on the door panel should have two 10mm bolts and a screw that holds it in place, be sure those are removed then use either a putty knife or flat tip screw driver or just your hands to pull the door panel push pins out, they are attached inside the door panel, just pull the door panel by the pins and should come off, if they break you can get new ones at any auto parts store or hardware store.

Mar 20, 2011 | 1998 Ford Explorer

1 Answer

Need to remove halfshaft wont pull out on passenger side on 1998 zx2


what i can advise you do if you absolutely cannot pull it by hand is to take a bent tip pry bar and help it out while pulling on it by hand. Remember too much force can break something :(

Apr 07, 2010 | 1999 Ford Escort

1 Answer

I have a 1998 ford explorer xlt turned wipers on last night they went half way up and now wont turn on.what can the problem be?


check to ensure the fuses are good first. also try and move the wipers on the outside with your hand while turning them on inside. if they move down and stop again the motor could be bad. checking for proper power and grounds is essentially in any good diagnostic, but wiring diagrams or a good understanding of how it works are needed for proper testing and diagnostics. More then likely the wiper motor may have given out. however in some cases the linkage or wiper transmission can let go from the motor so check to see if you hear the motor running with no wiper action. i hope this will help you

Jan 31, 2010 | 1998 Ford Explorer

1 Answer

I hawe a 2002 fird explorer and wont start will crank and hawe gas in system but no sparks on spark plugs


Roughly 4 possibilities. First to check would be ignition switch, by determining if power getting to coil when key turned on. Second would be coil. These days you have to take it in, but most part places will check it for free. Third it the control module. Same advice. Forth is the distributer pickup. Same advice again, except put the engine on TDC and mark the pointing of the rotor on the shaft, so that you can put the distributer back in more easily.

Oct 31, 2009 | 2002 Ford Explorer

1 Answer

1998 ford explorer wants to start but wont catch has fuel and spark????? plse help looking into cadillac converter any other ideas before i get out there and get dirty plse help


checkout the crank sensor and the timing give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your SUV wish you the best of luck Michigan Man.

Oct 20, 2009 | 1998 Ford Explorer

1 Answer

My door on the driver side of my 1998 ford explorer won't open from either side


Sounds like you need a new latch. You will have to try and get the panel off to access the inner workings, and it will be a pain in the ****, and may break.

Jul 13, 2009 | 1998 Ford Explorer

1 Answer

My cigaret lighter wont work on my 1998 ford explorer.


use a probe light and check if you have power to the centre connection at the bottom of the holder

Mar 15, 2009 | 1998 Ford Explorer

2 Answers

How to remove the upper intake manifold from the EGR tube.


just hit the upper intake with your hand to the left and that will do i t

Feb 24, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
1998 Ford Explorer Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...