Question about 1999 Chevrolet Silverado 1500

1 Answer

I have a 1998 siverado just replaced fuel pump and did a tune up. The check engine light is blinkin when I step on the gas. I know it is a code just not sure which one or how to reset the computer to compensate for the recent work done.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

Most big box auto stores will lend you a code reader. You can reset the code and know what it is! Unhooking the battery for a couple of hours usually works too.

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ol' lady bought a 2001 Jimmy a while back, n now she's havin probs. Found a block of wood btween oil pan nframe. Small prob but now sevice engine starts blinkin. It used to stop now stays blinkin. Runs...


This could be as simple as overfilling your gas tank, loose gas cap, or a loose connector somewhere. Then again, it could be a bad oxygen sensor, maf sensor, fuel injector, or intake manifold. Have you scanned the truck for any engine codes?

Running the engine while the check engine light is flashing can cause severe damage.You can burn valves or cat converters up and such. Catch it now before you need a new engine.

Nov 30, 2014 | Cars & Trucks

1 Answer

Nissan altima stalls


what are the codes that are causing the engine light to come on? need to know that first

Dec 03, 2012 | 1998 Nissan Altima

1 Answer

1989 grand prix starts and will idle but dies when i step on the accelator


Try a new gas filter and have the fuel pressure checked. Scan the engine computer for trouble codes. Check your air filter and replace if dirty or old. How old are your spark plugs, need new ones?
Maybe it just needs a tune up.

Mar 30, 2012 | 1998 Pontiac Grand Prix

1 Answer

Check engine light 1989 buick keeps coming on after replacing gas cap, fuel pump sensor and part of something of the evap system


doesn`t sound like you have had the code pulled to see what is turning the check light on.this is needed to know were to start diagnoises.do this first then ask for help with the code mentioned and what it stands for.

Oct 26, 2011 | 1998 Buick Century

1 Answer

98 passport 3.2v6 hard to start.must keep foot on gas untl engine warms up.check engine code PO101.replaced maf sensor.no change.thinking of checking for vacuum leak as next step.HELP


I had the same problem with my Passport and it was the fuel pump going bad. The pump was not producing enough pressure to get the fuel into the fuel system. A local shop discovered the problem when they did a pressure test on my fuel system.

Jun 04, 2011 | 1998 Honda Passport

1 Answer

Engine won't turn over...replaced battery, still not starting. alternator checked out ok. how can you confirm if it's fuel pump?


Hello inspiredtouc, your fuel pump is located in the gas tank. Turn your key to the on posisiton, without tuning to start the engine, go back by the gas tank and listen very closely, you should be able to hear the small motor on the fuel pump. You do have to listen real close.
Good luck my friend!

Jan 16, 2011 | 1998 Ford Explorer

1 Answer

I have a 1998 Olds Intrigue. Just had a tune up and replaced the upper intake manifold. Now I am getting a code that says the fuel is running too lean, Service Engine Light stays on. Also, When sitting...


Lean condition is a result of vacuum leaks, possibly at gaskets of upper manifold. You can check by spraying ether or carb cleaner at the gaskets with engine running. If engine revs at all, remove manifold to ensure gaskets properly installed.

Overheating: Make sure cable was reattached to temp sensor, and check for fan operation when engine gets hot.

if you have more questions, please let us know.

Sep 30, 2010 | 1998 Oldsmobile Intrigue

1 Answer

What are steps in tune-up for dodge dakota 1998 6


replace the air filter,pcv valve and spark plugs if over 60 k and the wires are original replace dist cap rotor and wires also then clean the throttle bore spotless with cab cleaner and a rag scan for any codes and sensors out of range there is no fuel filter (it is part of the fuel pump)

Sep 30, 2009 | 1998 Dodge Dakota

1 Answer

3.9 v6 4x4 check engine light, runs rough


Replace the ECT sensor.
And letme know. If you feel any diference. ok.

Aug 15, 2008 | 1998 Dodge Dakota

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...