Question about Jeep Grand Cherokee

2 Answers

How do you remove the driver side door panel on a 2004 Jeep Cherokee.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 17,970 Answers

- Remove trim plug from mirror flag bezel.
- Remove screws attaching trim panel to door
- Using a trim remover, detach trim panel perimeter push-in fasteners from door trim panel
- Lift trim panel upward and separate from door.
- If equipped, disconnect harness connectors for power accesories.
- Disconnect latch rods from inside handle actuator
- Finally, separate trim panel from vehicle.

I suggest check all information in the WJ Repair Manual Section 23 Body with graphics and other details.

Good luck (remember rated this help).


Posted on Feb 03, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How to remove the driver door panel on 2004 jeep grand cherokee.I removed three screws, but can't get ot off???Help

Posted on Feb 06, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 193 Answers

SOURCE: 1999 Jeep cherokee sport power door lock problem

If you would remove the door panel again, with the window rolled up, inspect the piece of linkage that is attached to the lock cylinder. It is held to the lock cylinder by a clip, then follow it down to where that same piece of linkage attaches to the door lock assembly. It is also held in place there by a clip, or at least it should be.

Insert a key in the outside of the lock cylinder and attempt to move the linkage. If there is a restriction, follow the linkage to find out why. It may be that the linkage has dropped off, or it may be the lock mechanism has jammed.

The reason it works from the inside is because a different piece of linkage operates the lock mechanism.

If you would like to contact me again about this or other problems, feel free to do so.
Bill
ASE Master Technician

Posted on Nov 25, 2008

  • 1348 Answers

SOURCE: 2004 Jeep Grand Cherokee Special Edition: Power

remove the switch assembly from the drivers door and look for a broken ground.

Posted on Jul 13, 2009

ZJLimited
  • 17970 Answers

SOURCE: how do you remove rear drivers side door panel on 2002 jeep

Several steps in here; review the KJ-2002-Liberty-Service-Manual-PDF-Secc-23-Body (page 128 and next).

I hope help you with this. Remember rated this help, good luck.


Posted on Sep 04, 2009

Testimonial: "THat information really helped thanks alot!!!"

  • 677 Answers

SOURCE: 2004 Jeep Grand Cherokee loud grinding sound when braking

It would be hard to guess at you electrical problems but get your brakes checked.It sounds like your pads have worn down to metal on metal.Very dangerous and can get expensive to fix the longer you leave it.A visual inspection can tell within minutes if this is the problem.If this isn't the problem the 2nd most common thing is a loose brake caliper or caliper mount.A friend with some mechanical knowledge will be able to check the brake pad thickness very easily and quickly with just a torch.Hope this helps

Posted on May 12, 2010

  • 1 Answer

SOURCE: 2006 Jeep liberty sport remove door panel driver side

2005 jeep liberty,the key will not unlock the driver side door and the power lock will not unlock the driver sider door.

Posted on May 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 2004 Jeep Grand Cherokee V8, the driver door control for the rear passenger side window does not work up or down, but the window control on the rear passenger side door works to make the window go...


Check wiring harness in between door and body, most likley there is a broken wire in this harness.
To get the window up you will need to remove the panel and apply a power and ground direcly to the moter connector. if it does not go up then reverse the polarity

Feb 18, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Power windows don't work on all 4 doors and power lock doesn't work on the driver door. 2004 jeep grand cherokee


On the driver side, the window/door lock module has the power lead either pulling away from the connection or has broke entirely. Another common cause is the wire harness between the door jam, this is the area that has a rubber boot covering the wires and from opening and closing the door, it creates a broken or loose connection over time. Open the driver side door, grab the rubber boot that the wires run thru, and move it around. Some times this will help create the connection and restore the power. If not, the door panel will need to be removed to inspect the wire connections.

Dec 31, 2010 | 2004 Jeep Grand Cherokee

1 Answer

2004 Jeep Grand Cherikee Laredo A/C stopped working


Could be the fuse, identify the fuse and with a fuse puller or a pair of needle-nose pliers, remove the fuse, if the wire in the fuse is broken, it's bad.

Mar 11, 2010 | 2004 Jeep Grand Cherokee

1 Answer

My power windows wont work on my 2004 jeep cherokee and my dome lights wont go off !! how do i replace this wire that i think is causing this problem?


I had this problem also.If you open the drivers door you will see the rubber boot that covers the wiring that goes into the door.You will have one or more wires inside of it broken.I had to pull the door panel and drivers side kick panel off in order to get enough slack to fix the wires.

Nov 02, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Passanger window just fell down, when i shut the door.


jUST REMOVE THE SCREWS AT BOTTOM AND POP HANDLE BLANK OUT A LITTLE SO CLIP CAN BE REMOVED AT HANDLE MAKE A **** PULLER OUT OF AN OLD PUTTY KNOFE AND CUT A SLOT IN IT . bUT GOOD ENOUGH FOR KNOW .

Jun 14, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Windows and lock wont operate on a 2004 Jeep Grand Cherokee


I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!

Mar 21, 2009 | 2004 Jeep Grand Cherokee

1 Answer

2004 Jeep Lerado - Drivers Side Power Windows & RemoteKey Issue


A wire in the rubber boot in the door jam is broken,i found it in my jeep GC 04 yours shouls be the same..

Dec 15, 2008 | 2004 Jeep Grand Cherokee

1 Answer

03 Jeep Grand Cherokee Driver side window


There are about 3 or 4 screws holding some molding at top and around the arm rest remove them. Starting at the bottom or back of panel put a small screwdriver or similar object between panel and metal of door and start prying slowly. You will need to buy replacement clips because usually they break when removing, but they are not that expensive. Just take your time and its not that hard. Had to take both off of wifes jeep to replace motor

Dec 14, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

544 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...