Question about 2001 Hyundai Accent

1 Answer

Vibration starting from 40 to 80 km/h the car vibrates even the doors then after 80 km/h the vibration disapears?????

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 583 Answers

Sounds very much as if the wheels need balancing

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have c180 2012 . i walked 6000 km and there is vibration in car when speed is 15 km and this happen only when i leave the accelator ... i need to know what is the problem in car


Please give more details. From were is vibration coming from front or rear, left or right side under car or inside. You said that it happens at 15 mph when u let off gas? Is there a clunk or noise before vibration starts? Many things could do this i need more details please. As it is it could be a drive train issue or as simple as a worn or out of balance tire.

Dec 04, 2013 | Mercedes-Benz C180 Cars & Trucks

Tip

PRADO 99 GX 4 CYLINDER 4WD


HI,
My prado 1999 4V 2.7CC 4WD M/T,
my car is vibrating on high way after 100 km speed, please help me for sending solution of fault. upto 100 km speed its runs smooth but after 100 km it start vibrating all body and interior.

other problem is for tires the one i purchase this car he replaced the four tires of the car by size 205, 70,16R actual size is 215,70,16R or 265,70 R16.please advise it is ok no problem to drive on present tires,

on Mar 24, 2010 | Toyota Land Cruiser Cars & Trucks

1 Answer

Vibration on acceleration


NEED MORE INFO.ARE THERE ANY CODES?IS VIBRATION IN STEERING WHEEL OR IN SEATS?WHAT VEH AND OR ENGINE SPEED DOES THIS TAKE PLACE?

Dec 28, 2011 | 2002 Kia Optima

1 Answer

I have a 2006 model scorpio, My vehicle has completed 3.0 lac km. Vehicle was having a lot of vibrations,I got replaced engine mounting & all the tyres.Steel some vibration's are their.Shall i...


It is most ideal that the job be done with a well equipped authorised service center. It is important that sine your vehicle had clocked so many kms, the entire vehicle needs a good closer look.
it must start with the engine, if there is vibration then there can be imbalance of the engine , need to check the condition of all four cylinders. Also the suspension, links and shocks, brakes, alignment and chassis/doors , hinges for rattling and vibrations.

May 11, 2011 | 2011 Mahindra Scorpio

1 Answer

Vibration from right front end


check wheel bearings , loose ball joints steering idler arm...

Aug 09, 2009 | 1998 GMC Jimmy

1 Answer

Vibration from the back change u joint still the same vibration between 40/60 km 1999 sierra 2wheel drive front end ok


Have your tires checked for any unusual wear or pitting and make sure that they are balanced right. If they are even just a little bit out of balance it can cause your back end to vibrate. Hope this helps. Good luck!

May 05, 2009 | 1999 GMC Sierra

1 Answer

Vibration


Could be a bad motor mount!

Feb 26, 2009 | 2004 Ford F150

1 Answer

Transmission shafts growl and the steering wheel vibrate


Either a loose nut or a broken/crack washer /rubber in the front transmition. AThis a headache to any dealer because the fron transmition will be dismantle to check on every piece. The reason it starts a60 is because the force/torque upon the washer and disapears at 100 because the force/torque upon the piece is so big the lock again
Regards
MSD

Sep 26, 2008 | 2006 Suzuki Vitara

Not finding what you are looking for?
2001 Hyundai Accent Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...