Question about Honda Accord

1 Answer

On my 2005 honda accord ex v4, i took 2 front seat and back seat and floor carpet out to clean went i put all the seat and carpet back, i start engine the red airbag is on and stay while engine running. what should i do to get that light turn off. Thank.

Posted by on

  • pdh9800 Feb 05, 2010

    But the honda dealer already taking care that problem on my 05 honda accord. What is the SPS in the
    sentence follow after this? (the drivers side seat wiring harness for the SPS being attached to the seat frame in the wrong location.) I have recheck the all wires and all of the connection under the seat, it has ok and connected correctly. In this case what should i do to dianotic check and turn off red airbag light without taking the car to dealer. Thank


1 Answer

Your airbag light has come on due to the drivers side seat wiring harness for the SPS being attached to the seat frame in the wrong location. The sensor wire has broke and caused your airbag warning light to stay on. Click on the link below to read about the recall for your 2005 Honda Accord. Take your car and this notice to the dealer and they will fix it for free.

Posted on Feb 03, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

For '91 honda accord ex; where is the engine "computer?"

It's located under the carpet, where the front passenger's foot rests on the floor.

Oct 06, 2011 | 1991 Honda Accord

1 Answer

How can i remove the driver seat of my '91 honda accord ex?

slide the seat all the way forward,, you will see the back 2 bolts,, then all the way back to see the front two

May 04, 2011 | 1991 Honda Accord

1 Answer

I have a 1997 full size cinversion van (Chev Cobra) I can'y get the inside engine access compartment open. I took out 2 upper bolts and the side spring clamps. The storage compartment seems to be hooked...

Lift the carpet ,on the floor between the seats to locate 2 more bolts. When removed the cover is kinda hard to remove.Lift bottom of cover to pull back the front and try to put the front part of cover to pasenger seat. Then roll the cover over and out the door

Mar 02, 2011 | Chevrolet Chevy Cars & Trucks

1 Answer

I have an 02 accord ex 4 cyl. that need the down stream o2 sensor replaced, where is the pigtail located ?

as you are looking at the exhaust you will see the catalytic conveter (large very hot peice) behild it is the downstream sensor the pig tail runs out of the back of the sensor, usually plugs and unplugs right the under the car if it runs through the floor board then you will have to pull the seat and go under the carpet

Feb 27, 2011 | 2006 Honda Accord

1 Answer

2005 honda accord,water puddles in floor on driver-side rear.Cannot find leak.HELP

it your back window its a common problem water is running down frame around the frame and into the back seat, pull up the back seat and pull back the carpet to confirm that this is the path of the water

Aug 30, 2010 | 2005 Honda Accord

2 Answers

Where is the ecm in the 1994 hnda accord

under the carpet on the passenger side floor board

Jun 11, 2010 | 1994 Honda Accord

1 Answer

2001 Accord EX and the front passenger carpet is soaking wet

try draining the evaporator box.. u can have a shop lift the vehicle and blow compressed air up the evaporator drain tube from under the vehicle..the tube is under the car from the area of the passenger should pour out almost immediatelt after shooting compressed air up the tube ...stand back if doin it urself..or u will take a shower...sounds like u have a clogged evaporator drain

Apr 09, 2009 | 2003 Honda Accord

1 Answer

Honda Accord brake light removal

It's a lot of work for just cleaning.
Fold the rear seat down and remove the two 12mm bolts on the bottom corners of the seat back, pull the seat out.
Between the seat bottom and the carpet you will find two tabs you need to pull and then pull the seat bottom up and out of the car.
Remove the two 10mm bolts securing the seat bolsters to the area the seat bottom was covering. Pull the seat bolsters up and out of the car.
Pop the "C" pillar trim off of the car (above the parcel shelf and beside the rear glass) (side airbag vehicles have a slightly different procedure.)
Pull up on the parcel shelf carefully and evenly. Remove clean and put everything back together.

Aug 16, 2008 | 2005 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides