Question about 2001 Chevrolet Impala

1 Answer

Replace combination switch 2001 impala

How to replace combination switch 2001 impala

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 204 Answers

Which combination switch? Headlights, windows, etc????

Posted on Feb 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 impala igntition switch going out can i use my old key when i replace my switch


Yes you can take the ignition switch with the old key to a locksmith and have them rekey it

Mar 28, 2012 | 2001 Chevrolet Impala

1 Answer

2001 impala replaced ignition switch, now wont turn over. NO security in message center


Unless you used the correct coded key cylinder the engine will not start.

Mar 28, 2017 | Chevrolet Impala Cars & Trucks

1 Answer

Compressor will not engage on 2001 Impala? Where is low pressure switch located on 2001 Impala


It is located by the accumulator or dryer , a long canister shaped part, that will

have a pressure switch attached to it, and a two wire molex, if there is freon pressure

in the cannistor, the switch will close and send voltage to engage the clutch on

the compressor, if there is no voltage there the clutch will not work and you may

have a blown fuse or bad switch on your dashboard. i would check for voltage

at the pressure switch 1st, if its there, pull the molex off , jump it out and see if

the clutch engages. if you have power and you jump out the molex and the

clutch does not engage, you could have a bad clutch or bad compressor.

if it does engage, just replace the pressure switch, if you do replace it, make

sure to lube the seal with pag oil. good luck!

Jun 28, 2011 | 2001 Chevrolet Impala

2 Answers

I am having a problem with my emergency flashers on my 2001 chevrolet impala, when i press the button for them to come on they work fine, but when I press the button for them to go off they go off but the...


Good Evening Faith. General motors had problems with thier combination hazard switch. The reason it is called a combination hazard switch is because it is also your turn signal and hazard flasher. On the Oldsmobile Alero, pontiac grand am there was a recall, as far as the impalas and monte carlos I cannot say for certain. Your local parts house (autozone, Advanced, Oreilleys) should have them or be able to order it. That should correct your problem. Hope this helps.

Aug 07, 2010 | 2001 Chevrolet Impala

1 Answer

Ignition switch 2001 chevrolet impala


YOU NEED A HAYNES REPAIR MANUAL WITH PHOTOS TO SHOW YOU HOW TO REMOVE STEERING WHEEL AND DISABLE AIRBAGS.YOUR IGNITION SWITCH IS IN THE STEERING COLUMN.

Jul 07, 2010 | 2001 Chevrolet Impala

3 Answers

Ignition control module on a 2001 Chevy Impala


There is a switch relay that plugs behine the ignition switch cylinder.You would have to take apart the dash console to take it apart to replace it.Also helps solve a few problem on the 2001 chevrolet impala, with heat gauage not working and a/c not blowing cold air anymore.Replacing it, should fix the problem with that.

Apr 11, 2010 | 2001 Chevrolet Impala

1 Answer

1 2 3 will not work on my air control plue the control for the outside air and inside recirculation will not switch 2001 Chevrolet Impala


replace blower resistor,its a commom problem,it use a diode and it dont let power go thru resistors because it open internally

Nov 24, 2009 | 2001 Chevrolet Impala

1 Answer

Drivers side power window does not go up on 2001 Chevy Impala. Anything I can do before replacing the whole switch?


See if you are getting voltage to the window lift motor. (You have to remove the door panel) Unplug the harness at the motor and see if you get positive and a ground while moving the switch at the harness that comes from the switch. If you do, the window motor is bad.

Oct 04, 2009 | 2001 Chevrolet Impala

1 Answer

My 2001 Impala's blinkers only will sometimes and sometimes they dont work. and also gas single is either on full or empty help please


need to replace turn signal switch and fuel pump the gauge sendingunit is all 1 part of the fuel pump

Mar 03, 2009 | 2001 Chevrolet Impala

Not finding what you are looking for?
2001 Chevrolet Impala Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...