Question about Ford Laser

1 Answer

1988 laser, starting problem and rev's too high

Hey hey, iv got a 1988 laser GL 1.3, if it hasnt been driven for a couple hours it struggles to start, then when it does start the rev's are really high in neutral. it drives itself! just lift the clutch and your off! any ideas? Cheers

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Get rid of now its a death trap

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After running my johnson 4hp 2s for a couple of hours in the bay it starting giving a strange noise and then cut out.i managed to get it started again but coudnt get above half speed.


Hey Pete.. this sounds serious.... will it rev up while in neutral? If it revs freely and high.. the power head should be ok.. if it will NOT rev up freely and high.. STOP - you are causing more damage..
Check the compression with a good gauge..it should be 125psi minimum.. with no more than 10 psi difference between any two cylinders.. DO this WITH the THROTTLE WIDE OPEN...
Can you turn the propeller by hand while it is in neutral?..Of not.. this is the problem.
Shop Evinrude Outboard Parts Johnson Outboard Parts
Lower Unit Replacement Rebuilt Lower Units Aftermarket Lower Units
REMANUFACTURED LOWER UNITS
https://www.boatengine.com/lower-units/remanufacture
Refurbished Lower Units for Yamaha Mercury OMC Johnson Evinrude

Jul 09, 2017 | Cars & Trucks

1 Answer

1988 toyota camry shut off while driving


i would replace the fuel filter, not being driven thath often has probably clogged it up with trash

Jan 25, 2013 | 1988 Toyota 4Runner

1 Answer

Hi i have problem with my 53 reg 1.8 sxi vectra c when starting engine from cold idling is not right car cannot be driven away until warm because revs are erratic but once the cars warm its fine a few week...


You need to have the engine control module scanned for fault codes, when that check engine light came on a fault code was stored, that code is likely the key to diagnosing this problem

Apr 05, 2017 | 1990 Volkswagen agon GL

1 Answer

Engine over revving at idle


looks like yor air valve is not working properly.check the water imput (could be clogged). also,did you removed your termostat? if so,put it back and solve the problem.

May 07, 2009 | 1984 Toyota Corolla

1 Answer

'88 VW Golf GL Starts for seconds but dies.


check the air filter
fuel filter *
test the alternator

Apr 09, 2009 | 1988 Volkswagen Golf

1 Answer

A/T, Battery light stay on in 1988 Dodge Raider


new brake light switch,check that a mouse hasnt munched cables under bonnet or behind dash.Then tour dealers and recycle this beast and buy a nice low emission eco friendly car and do your bit to save the planet

Jan 28, 2009 | 1988 Dodge Raider

1 Answer

1984 gl 1500 laser


hey ive had a simular problem on a old car,replace ur ignition coil
hope this is of help to you
cheers alvin

Jul 14, 2008 | Ford Laser Cars & Trucks

1 Answer

1.6 vitara


hey, check your coolant level on your radiator, take note I said " radiator not coolant reservoir.

there could be low coolant level that causes it.

Jun 24, 2008 | 2001 Suzuki Vitara

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...