Question about 1995 Nissan Altima

1 Answer

My RPM gauge on the dash board does not work as normal. RMP moves very slow and the check engine light is on. Please help?! =(

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Your ground might be loose

Posted on Feb 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do the RPM gauge supose to move up on dash when cranking?


The tach readout is controlled by software in the Instrument cluster (IC) based on the values sent from the VCM/PCM. The readout on your scanner should show the correct rpm values (120 to 240 is wrong). Therefore, if the engine is running normally, the computer is probably not sending the correct values to the IC, but the crank sensor is OK.

Jan 01, 2017 | GMC Cars & Trucks

2 Answers

My rpm gauge is red lining on my dash board


The rpm signal comes from the ignition module, since that is related to the engine speed, that you said is fine, most likely the dashboard gage is acting up, could be a nussainse but, wouldn't afect anything else, of course if bothers you need to replace the whole thing since I'm pretty sure it's not serviceable.

May 15, 2014 | 1997 Honda Civic

1 Answer

1996 camry lost speedometer and a/c while driving. Put in new battery and alternator, still no change and now car just lost all power while driving . What is wrong with car?


lost speedometer, what does that mean 0mph at 50? ??????
YES, CHECK all fuses first. all cars, for any electric issues.

A./c lost, (ok there are 6 things that cut A/c some are normal)
one is HVAC dash blower fan must blow or AC brain cuts A.C
this prevent ICE up. (normal)
please:
why guess? please stop guessing and throwing parts and cash.
what does lost all power, driving mean.???
lost engine power (cant drive)
or lost all electric power (a prime reason for EFI to die , for lack of 12vdc electric power)
does lights die on the car, at the moment of problems?
Dash cluster , head lights, any lights.
does engine STALL? (0 RPM is stall) 300 RPM is bad idle.
800 RPM is normal hot idle, never less.

if this is just and engine power issue, (cant drive at all ,or only slow or
slow up hills?)O
my car will not move fast,? in any gear? and transmission don't slip
and no DTC scan codes (checked and smart to do first)

I'd be all over fuel pressure. this is a $20 gauge , that must be connected to the fuel rail to read pressure.
28psi is minimum for all cars.
if i knew what engine was in your car, id look yours up
alldata.com has this info.

the ecu can not report wrong fuel pressure, it cant
so is always and issue, with total engine power loss.
so is skipping 60,000 mile FULL TUNEUP's

if you need those charts they are easy to get. for any car.

tell more get more.... regards

Feb 20, 2014 | 1996 Toyota Camry

1 Answer

Battery gauge moves


check for belt tightness it sounds like the belt is slipping or the idle rpm is too low (near 500) to keep the alternator suppying enough power to run the car(or it is too small amperage alternator for the car anyway..) get tested for free at autozone or parts store..

Dec 24, 2013 | 2006 Isuzu Ascender

1 Answer

Interior lights went out


Check fuses, and then the bulb inside dash.

Aug 08, 2012 | 2007 Chrysler Sebring Sedan

1 Answer

None of the dash gages work no fuel, no rpm no speedometer


If you haven't done this already, check your fuse, for dash gauges. Go to the left side, inside your engine compartment to your control panel and check the fuses. Also check the fuses in your interior fuse panel, which is located at the left end of your dash board. Pull the handle with your fingers and check the fuses inside. I would think if all your gauges are out then it should be a fuse. I hope this will help you. Please vote. GOOD LUCK.

Jun 05, 2011 | 1996 Dodge Grand Caravan

1 Answer

Oil gauge goes to zero when stopped or idle. No leaking, engine working good. Put oil in two days ago and again yesterday. Due for oil change in a couple of weeks. Light on dash board "check...


Possible that the OIL filter is clogged and is reducing the pressure due to this when the engine is idling or in low RPM. So before you run the engine further and make it more damaging , it is worth to have the engine oil / oil filter changed. If there is still no result, check the oil pressure switch. If not the oil pump can be faulty. This needs a technical help and should be consulted.

Feb 02, 2011 | 2001 Jeep Grand Cherokee

1 Answer

1987 Dodge B150 "Check EGR" light?


hello, if you have a vacuum pull off choke, you can try replacing your thermal vacuum valve on the intake manifold, it fits with the slow rpm..s at cold start!! Good luck, cheap repair if it works for ya. marty

Aug 10, 2008 | 1987 Dodge Ram Wagon B250

Not finding what you are looking for?
1995 Nissan Altima Logo

Related Topics:

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...