Question about 2002 Ford F150 Regular Cab

1 Answer

Cruise control will not turn on. light on dash use to come on. cruise will not work. checked fuse it is ok

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 984 Answers

Did you have the recall for the cruise control done ?
recall 05S28. Description: Speed Control Deactivation Switch.

It could be the fuse in the recall harness is blown.

Try the Cruise Control Self test :
----------------------------------
Self-Test Diagnostics

WARNING:
This test is a key on engine off (KOEO) test only that is conducted in park only with emergency brake fully engaged.

1. Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.

2. Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL.

If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.

The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch.

Note:
There will be a slight delay when the last button is pressed and the lamp flashes.

3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective.

If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:

— 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).

— 3 flashes - deactivator switch is open or circuit defective.

— 4 flashes - vehicle speed signal is out of range or circuit is defective

4. Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.

5. Return the ignition switch to the OFF position and proceed to the Symptom Chart.
----------------------------

If the Cruise Control does not enter self test, the fuse in the recall harness ( if done ) is most likely blown and needs to be replaced.

Posted on Feb 05, 2010

Testimonial: "thank you very much"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 436 Answers

SOURCE: the horn and cruise control doesn't work,fuses are

the horn input to ground is located in the cruise control module. if they both don't work then your cruise control module or the clockspring coil for the steering wheel needs to be replaced. If airbag lights is on as well then I would change the clockspring coil first.

Posted on Oct 02, 2009

  • 811 Answers

SOURCE: Please help....I have a 2002 Acura TL Type S. The

check under hood for other fuses or relays

Posted on Sep 27, 2009

  • 1043 Answers

SOURCE: 2003 Denali Yukon, no Brake lights, no Cruise Control, fuse is OK

Check your brake light switch at the pedal. This controls the lights and disengages the cruise when stopping. I'd look there before I go anywhere else. There may just be a wire loose. Could be a simple fix.

Good Luck and hope this helps.

Posted on Mar 15, 2009

dgjtex
  • 405 Answers

SOURCE: 2003 expedition cruise control inoperative

Dave, I am sorry I can't help you, but it sounds like you know what your doing, all I can do is offer you the troubleshoot guide, for a ford car cruise control, which should be the same. You can purchase for 20.00 on alldatadiy.com and it will give you all service info on your specific vehicle for a year. I think it is well worth the money, and generally when I need to repair any vehicle with problems it has been a life saver. I am pretty sure the electronics for this are contained in the cruise module it's self. Alldata will have a trouble shooting guide that will walk you through the repair. It could be the actual button on the steering wheel, it could be the module. You can buy these pretty cheap if you go to car-parts.com and put in what you need. Of course these are used but most yards give a warranty on them.

Posted on Dec 15, 2008

mrgreenz
  • 962 Answers

SOURCE: 2003 expedition cruise control inoperative no

Check the speed sensor at the tranny or near left front tire. Use a manual or find the location on the net. This sensor usually causes problems with the cruise control.

Posted on Nov 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 Dodge Ram 1500 cruise control will not turn on. I've checked the fuses in the fuse box on the side of the dash but they were all good. Another issue i have occasionally is the brake light


Probably neither.
The brake light switch could knock out the cruise.
You might check the computer for trouble codes, but you'll probably need a shop manual to get the test procedures for the cruise control.

Oct 12, 2012 | Dodge Cars & Trucks

1 Answer

Cruise control stop working on my 2007 dodge ram, hemi.


check the fuses inside the car there is a fuse box under the dash

Sep 02, 2012 | 2007 Dodge Ram 1500 Quad Cab Sport

1 Answer

Cruise control , speedometer and dash lights work intermitently


There is an intermittant connection in the cluster wiring harness> you will have to start by removing the clusyer and checking the dash connectors to make sure they are seated, if ok trace the harness to the fuse block and make it has all connectors tight > check all grounds at dash and fuse block for continuty to ground.>check power and ground at cruise module.

Mar 24, 2012 | Nissan Sentra Cars & Trucks

2 Answers

2002 Ford F 150 Supercrew,,,,5.4. noticed cruise control stopped working.........next day,,turned on a/c ,,fan motor works,,,no cold air,,,,,,,,,,,,tried turning on heat,,,,,,fan works, no HOT air....


try disconnecting the cluster fuse and the radio fuse and see what happen if everything work...u might have an open circuit or a short on one of the electronic in your truck

Apr 21, 2010 | 2002 Ford F150 Regular Cab

2 Answers

2003 expedition cruise control inoperative no cruise light on dash when buttom is pushed. All fuses in fuse box checked OK. No data stream information on cruise buttons.


Check the speed sensor at the tranny or near left front tire. Use a manual or find the location on the net. This sensor usually causes problems with the cruise control.

Nov 20, 2009 | 2003 Ford Expedition

1 Answer

Cruise control does not work


HI, check the fuse in the fuse box under the dash on the driver side kick panel. if the fuse is ok, this will confirm an issue that will concern the cruse control module/amplifier and, Cruise servo. these components may need to be replaced.

The power solenoid could be affected as well. inspect the entire cruise control assembly under the hood if the fuse is ok.

Jun 25, 2009 | 2001 Ford Focus

2 Answers

Cruise Control on 2 door Sport 4x4 with SOHC: Non-working cruise control. When turned on, cruise control does not engage, no dash light indication either.


look in your owner's manual for the location of the cruse control fuse it is different from other fuses usually much larger

May 21, 2009 | 1999 Ford Explorer

1 Answer

Cruise control 1998 plymouth grand voyager not working


Check fuses under dash on drivers side, & fuse & relay box under hood on drivers side. I.D. for fuses & relays under hood on underside of cover.

Apr 09, 2009 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
2002 Ford F150 Regular Cab Logo

1,705 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...