Question about 1999 Mercury Villager

1 Answer

1999 mercury villager put in new blower motor and resistor. Every so often when change modes from defrost to lower for example or on start up it blows the front blower motor fuse. the blower motor is a Ford unit. Is there anything else on that circuit that could cause this. Going to try new blower motor relay.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

It could be the electronic blend door motor. Try not changing any settings for a week and see if the fuse blows. Leave it on floor/defrost.

usually it is the bearing in the blower motor going bad. I believe it's a 25 amp fuse. The motor draws about one amp for each volt increase up to 14 volts.

go to our site for more help.

http://groups.yahoo.com/group/villagerquest/

Posted on Feb 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

BLOWER MOTOR RESISTOR ITS NEW AND BLOWER MOTOR ITSTILL NOT WORKING


first check all your fuses then the blower motor relay and the blower motor itself, some times very rare cimate control goes bad but i dont think this is the case, hope this heps you.

Feb 06, 2011 | 1999 Mercury Villager

1 Answer

We have a 2002 villager, the fan only works on Hi setting, Checked the 20 Amp fuse in the panel to the left of the steering column, as well as the larger fuse in the engine compartment. Both are fine. Is...


The blower motor doesn't use a different fuse depending on the speed. The most common cause for your concern is bad blower motor resistors. The resistors lower the voltage to the blower motor so it doesn't turn at full speed when you have it set to fan speed 1. When the resistors blow out the only setting that works is full speed because it doesn't go through the resistor.

Sep 05, 2010 | 1999 Mercury Villager

1 Answer

Heater blower will not run


Check for 12v at the blower motor connector,

If no current then the switch is bad, or the relay is bad.

Obviously check your fuse as well.

Could also be your blower motor resistor if the fan only works on high speed on not the lower speeds.

Apr 01, 2010 | 1999 Mercury Villager

1 Answer

Heater fan only works on "high speed"


All cars are designed with a blower fan motor that pushes air through the ventilation system. This air is processed by a series of vents to direct the air to various positions. Example: heater, air conditioner and defrost modes. Most blower motors are power by a basic electrical circuit that utilizes a multi resistor or a solid-state resistor to control different fan speed modes (low, medium low, medium and high). If the resistor malfunctions it may lose one or more of the lower fan speed settings.
google_protectAndRun("ads_core.google_render_ad", google_handleError, google_render_ad);

Mar 02, 2010 | 1999 Buick Century

2 Answers

Mercury Cougar heater blower only works on high.


remove the trim panel below the glove box and you will see the blower motor,just to the left of it you will see a 4 wire connector plugged into the case. This is the blower motor resistor,this is what you need to replace.

Feb 12, 2009 | 1999 Mercury Villager

4 Answers

Blower motor resistor


Hi..The Blower Motor Resistor is located under the glove compartment, pass side. You do not need to remove the glove box, or anything. Look under the dash on the pass side and you will see the resistor with the wires leading to it. (looks about the width of a Credit card) Simply undo the ( 2 ) 9 or 10mm screws from the resistor, slide/pull it down from the slot, un-clip the wire harness and replace with the new resistor. Screw it back up. Thats it. Takes about 4 minutes. The dealer wants $125.+ to do the job. The resistor is about $24.00.
Good Luck. If it keeps blowing, the blower motor is probably drawing too many amps. Then you have to switch that out.
Mike

Dec 06, 2008 | 1999 Mercury Villager

1 Answer

Where is the heater blower motor resistor located


if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Dec 06, 2008 | 1999 Mercury Villager

Not finding what you are looking for?
1999 Mercury Villager Logo

Related Topics:

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...