Question about 1999 Oldsmobile Aurora

Open Question

1999 olds aurora -electronic level control not working? Back end drives rough. How hard is it to fix?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1999 olds aurora starter

The starter is located under the intake manifold.

Posted on Oct 02, 2008

  • 834 Answers

SOURCE: electronic level control not working right

To begin with, check the "ride level" fuse and make sure that the ride level compressor does work, and you should be able to hear that the ride level compressor is working when the ride level system is leveling the vehicle.

The ride level system uses an air compressor and either an air type of shocks or a type of air billow to raise and lower the vehicle, there is an adjustment to set the ride height and it is located under the vehicle and there is a control lever or rod that should be connected between the rear axle and a switch that is mounted on the body of the vehicle, and there will be an adjustment slot in the control lever between the switch and the body, and that is how you would adjust the ride level height, but be sure that the vehicle can not drop any further down if someone is under the vehicle trying to adjust the ride height.

However, you might find that the control lever to the ride level has fallen off from the switch on the body or it has come loose from the rear axle, and it is just hanging there not operating the switch on the body that controls the the ride level compressor, or there might be a blown out air shock or billow, or you might find that an air line from the compressor is leaking and the ride level compressor will just run continuously until it blows out the fuse, and if that is the case you might also find out that the air compressor has burned out from running continuously.

Posted on Jun 12, 2010

  • 615 Answers

SOURCE: where is the starter on a 1999 olds aurora...

Under the intake manifold. You need to remove the fuel rails and manifold to get to it. Not too difficult (about 2 hours)

Posted on Oct 12, 2010

  • 615 Answers

SOURCE: why is my oldsmobile aurora electronic level

The motor is probably frozen causing the fuse to blow.

Posted on Nov 03, 2010

  • 844 Answers

SOURCE: pump noise in rear of car keeps running / Gas pump

you might have a leak in the rear suspension load leveler. check connections with soapy water. locate where sound is coming from. fuel pump in tank is a slight hum and not that noticable, but the air comp for load leveler is. Also spray around rubber boots on shocks, also check load leveler switch on axle to frame for broken or loose lever control.

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can cause a 97 aurora olds. To idol high in drive?


Hi, Check for any Vacuum leaks. This can cause for engine to idle high or even rough. One other thing is a bad idol air control. Hope that helps. Go to your mechanic and have him do a computer code check.

Oct 23, 2014 | 1997 Oldsmobile Aurora

1 Answer

How to replace dome light bulb 1999 olds aurora


Squeeze or slide the cover off . And the bulb will be attached at both ends , just grab at the center and pull it toward you !

Apr 30, 2014 | 1999 Oldsmobile Aurora

1 Answer

Pump noise in rear of car keeps running / Gas pump or load leveller / seems longer run time olately in cold weather ( 1999 olds aurora)


you might have a leak in the rear suspension load leveler. check connections with soapy water. locate where sound is coming from. fuel pump in tank is a slight hum and not that noticable, but the air comp for load leveler is. Also spray around rubber boots on shocks, also check load leveler switch on axle to frame for broken or loose lever control.

Jan 21, 2011 | 1999 Oldsmobile Aurora

1 Answer

Why is my oldsmobile aurora electronic level


The motor is probably frozen causing the fuse to blow.

May 28, 2010 | 1995 Oldsmobile Aurora

2 Answers

Fuel Filter location


front of the fuel tank a few feet away.. just follow the fuel lines to it. it has snap in clips going into the filter ends

Feb 23, 2010 | 2001 Oldsmobile Aurora

1 Answer

The windshield washer hoses on the 1996 Oldsmobile Aurora need replaced - The reservoir is not defective and we need to know how much this problem should cost to fix


This is something you can easily do yourself for about $20 or less. That hose is the same as vacuum line.take a small piece with you to the autoparts store, to be sure you have the right size, and buy enough vacuum line to replace your hoses. Get a rough measurement before you go, probably 10 feet or so and it is about $1 a foot. Use the old lines to measure out the new ones.
If the old lines don't want to pull off fairly easy, then use a sharp knife or razer blade to cut them off the plastic fittings. In the cold the plastic will break quite easily, so be careful.If the new hose is giving you a hard time going back on then put the ends in some boiling water for a minute or so and they'll slide right on. Hope this helps.

Jan 13, 2010 | 1996 Oldsmobile Aurora

3 Answers

1999 olds aurora starter


The starter is located under the intake manifold.

Sep 13, 2008 | 1999 Oldsmobile Aurora

2 Answers

99 olds aurora


Don't replace the entire switch, clean any of the relays or take the switch apart. You'll notice at the back of that switch where wires are attached to the blades that they are exposed. My guess is that you'll also notice the tilt steering wheel "release" is bare metal and in very close proximity. Insulate the lever with something (I cut apart a plastic water bottle, melted it in half, then fused the ends with a butane soldering torch) and put everyhting back together). The blades at the back of the switch are arcing across to the tilt lever.

voila

Jun 27, 2008 | 1999 Oldsmobile Aurora

Not finding what you are looking for?
1999 Oldsmobile Aurora Logo

Related Topics:

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...