Question about 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

The windsheild washers and the blinkers just stopped working is there a relay or something that might be bad.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 7 tips or uploaded 3 video tips

  • Dodge Master
  • 680 Answers

I'd try replacing the combination switch/multifunction switch on the column. It's relatively easy to do and is most likely the source of your problem. If I remember correctly, there are 4 screws that hold the column cover on on the lower column, just above the knee bolster. And three screws that hold in the switch. (Turn signal arm)

Posted on Feb 21, 2010

Testimonial: "Thanks! You are right on. I checked all the fuses,then talked to my brother in law he thought the switch was bad too. Hes fixing it today. Thanks!"


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the windsheild washer relay ?

front or rear?
nice guess, huh? asking for something, never seen, or shown
in the schematic? well i logged into and there is no such thing.

why not ask why, it does this an not guess.
this car has a 1 wire wiper motors.
that means all actions are the reults of this,,,,,

windshield wiper control module , WWCM?
so it its bad.
or its inputs are wrong. (logic)

there are only 2 inputs from the Multifucition switch
if they are wrong, the wiper will fail
if they are correct then the WWCM is bad.

Jun 17, 2014 | 1999 GMC Jimmy

1 Answer

Door loocks clicking when seatbelt latched

it sounds like they may have damaged the fuse box where the relay for the blinkers is. or put a relay in the wrong one some relays look the same but are a different colour, but have the same pin out putting the wrong relay in the wrong slot could cause this.

Jun 12, 2017 | Pontiac Grand Am Cars & Trucks

2 Answers

1988 jeep cherokee,6 cylinder my front windsheild wipers dont work.fuse is good.the wiper motor makes a noise when its turned there a relay that could be faulty?wiper switch is the same as the turn...

No relay in the circuit.
There is a delay module but if it fails that usually causes the wipers to stop in the middle of travel or only run on high.
And the switch is working if you hear noise coming from the motor. The wiper switch is not the same switch as the turn signals but it is near that assembly.
I would say if you have power to the wiper motor the motor is probably dead or something happened to the linkage to the arms.

Feb 27, 2013 | 1988 Jeep Cherokee

1 Answer

My blinkers will just stop working. I just had a new multi-function switch replaced and it is still doing it. I can manually turn the blinker off and on and the blinker light works.

Looks like the blinker relay needs to be replace! It blinks once and stop, means the relay bi metal is burned and have to be replace.
hope that helps you out!

Jun 09, 2011 | 2004 Ford Expedition

1 Answer

My windsheild wipers,radio and blinkers do not work, I turned the car back on and nothing, could it be fuses go out at one time?

make sure to check all you fuses alot of times dodge has the wiring setup so that if one fuse blows multiple things will stop working

Feb 21, 2010 | 1995 Dodge Neon

1 Answer

My turn signals wont work... not even the blinker light on the inside will turn on... but when i lock my truck the lights will still flash and everything.. just the lever inside wont click them on

We had the same problem and its the windsheild/turn signal switch that has gone bad so you are going to have to buy a new switch or have no turn signal or 4ways. The whole windsheild /turn signal/4 ways is around $100 - $150.

Dec 03, 2009 | 1995 Chevrolet C1500

1 Answer

Driver side rear blinker/stop light does not work, also 3rd light stop light isn't working either

may be a bad electronic flasher unit if you lost both. if the blinkers flash very fast, that is a bulb out warning, but sometimes the flasher controls both circuits, and it is a relay.

Jul 22, 2009 | 1999 Ford F150 Regular Cab

1 Answer

Windshield wipers stay on delay all the time.

A wire is shorted out or part of the switch is bad.

Aug 27, 2008 | 2003 Buick LeSabre

Not finding what you are looking for?
2007 Dodge Caravan SXT Minivan New Cars Logo

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides