Question about 2002 Chevrolet Express

1 Answer

Can i remove an oil pan on my 2002 chevy express van without removing the engine?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 39 Answers

Unfortunately no, you will need to remove the engine. There are short cuts, but not worth it for DIY. Body needs to come off frame, so unless you have a lift and an engine hoist, I would take it to a pro.

Posted on Feb 02, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you change the oil pump in a 1995 chevy lumina 3100


You must remove the oil pan. I do not think you can do this with the engine in the car. If you can remvove the pan from the bottom without engine removal, it would be easy. Most every engine has to be removed to fully remove the oilpan. So my solution is- remove engine, remove oilpan, remove pump, replace pump, pan, and engine.

Dec 04, 2013 | Chevrolet Lumina APV Cars & Trucks

1 Answer

2005 chevy van 2500 express is leaking tranmission fluid at pan


wipe everything clean and drive for a day to verify where the fluid is coming from. if it is coming from the pan then drain and remove the pan and replace the gasket. if not the replace the offending part or gasket.

Nov 25, 2013 | 1987 Ford Ranger

1 Answer

My oil dipstick is broken. its the plastic thing on the edge with mark "min - max" I can not check the oil because only see "max". do you know where I can get replacement for 2002 chevy express 1500 cargo...


HI IF YOU LOOK UNDER THE CAR YOU WILL SEE A OIL PAN WHERE THE OIL STARTS FOR THIS ITEM THAT AS BROKEN OFF WILL BE AT THE BOTTOM OF PAN AND WILL NOT MOVE FROM THE SPOT IT FELL

Oct 04, 2013 | 2002 Chevrolet Express

2 Answers

I need to find the location of the fuel filter on a 2001 chevy express 2500 van, so I can replace it.


typically it will be right under the drivers door along the frame rail. Some of these vans including the Savanna vans have a non servicable fuel filter

Mar 18, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

Where is the starter located on my 2000 chevy


Under your van on the passenger side just above the oil pan on the side of the engine block, bolts into the transmission bell housing, hope this was very helpful.

May 11, 2010 | 2000 Chevrolet Express Cargo

2 Answers

Replace Oil Pump Can it be doen without pulling


Yes it can. It can be replaced from the underside by removing the oil pan

May 03, 2010 | 1998 Ford Windstar

1 Answer

How to replace a oil pump


Probably a 3 out of 5 on my diy difficulty scale, here goes: 1 remove negative battery cable 2 raise and support the van on jack stands 3 remove the motor mount bolts from both sides( do not worry the engine will not fall on you) 4 remove the oil pan retaining bolts 5 unplug oil level sensor if equipped 6 bump oil pan with a RUBBER mallet to break the gasket seal 7 remove oil pan, you might have to raise the engine with a jack placed under the front pulley, use a block of wood to avoid marring the pulley, and raise the engine just enough to allow the oil pan to slip out. 8 remove the oil pump retaining bolt and allow the pump to come straight down. 9 you will have to re use the intermediate shaft, the collar that holds it on will most likely break when you try to remove it, you can get a new one, it will probably come with the new oil pump. You can reuse the oil pump pickup tube, but it is cheap insurance to replace it. reassemble in reverse order, pay attention to the oil pan gasket, be careful and get the corners in correctly, extra time spent here will prevent a leak later.

Mar 18, 2010 | 1999 Chevrolet Express

1 Answer

My oil pan is cracked and I want to know if I have to remove the engine to change this.


If you can see and get to all of the bolts which hold the oil pan to the bottom of the engine and if it appears obvious that the oil pan can be removed without being blocked by anything else, then you don't have to remove the engine. Come to think of it, I don't think that I have ever seen a car where you had to remove the engine in order to remove the oil pan.

Apr 20, 2009 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
2002 Chevrolet Express Logo

467 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...