Question about 1965 Ford Mustang

1 Answer

How to install 69 mustang trunk lid?1969 mustang

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 396 Answers

Need some clarification. The entire lid or the hinges. Either way, it is a lot easier with 2 people. You may want to remove the hinge torsion springs.

Posted on Feb 02, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

69 mustang hood flasher wiring diagram

If the hood is original to the car whoever removed the wiring may have simply taped it into the wire harness on the firewall. If they have been removed or cut off, you can locate the corresponding wires in the firewall harness and splice into it with the hood harness. Otherwise you may have to purchase both wire harness from a specialty warehouse and that will be expensive. If there are no wires/plug taped into the firewall harness there is also a possibility that the car didn't come with the hood signals and the hood was added later.

Sep 01, 2014 | Ford Mustang Cars & Trucks

1 Answer

1968 gto refrigerant capacity ?

according to an old Chilton's Repair Manual I have (1969) the refrigerant capacity is 4 1/4 lbs.for the '63-'69 pontiac and the '63-'69 Tempest is 3 3/4 lbs. Since the GTO would be an 8 cylinder I would expect the higher capacity. The oil capacity is 6 qts. plus 1 for a new filter for both the 350 and 400 CID

Jul 13, 2014 | 1968 Pontiac GTO

1 Answer

New 1969 c4 auto transmission has park but no reverse or netural

Is it possible the transmission was not made for a Mustang ?
With the shifter on the floor, the linkage would be different than a car with the shifter on the column.
Have you contacted the company ?

Aug 25, 2012 | Ford Cars & Trucks

1 Answer

My 1969 mustang is vapor locking. what can i do to fix it

I have never herd of a vaper lock on a 69 mustang. Try to change your fuel pump or in line filter hope this helps CJ

May 25, 2010 | 1989 GMC Suburban

1 Answer

How to install trunk lid trim on 1968 mustang? A lot of brackets and only a couple of nuts. Any idea? I don't have any pre-drilled holes either.

the two nuts go at the end of the trim two bolts sticking out of the trim drill two holes at the ends of trunk which should all ready be there. the middle clips go along the middle the trim snaps on to them

Bruce Pike

Oct 10, 2009 | Ford Mustang Cars & Trucks

2 Answers

1969 ford mustang mach 1 brake / stop light switch challenge

Most tail light problems are a result of a bad ground......somewhere.

Sep 16, 2008 | 1966 Ford Mustang

1 Answer

Trunk lid

do you have the striker plate missing? if not i had spryed some WD-40 on my and it worked. if you have striker plate missing try to put some tape,(electrical tape). you can find these parts at, part #TLSP5 they are about $30 or less

Aug 01, 2008 | 1998 Ford Mustang

1 Answer

69 chevy p/u

This might be a good place to start:

I don't know if you are near any larger cities but bigger public libraries often have older Chilton and sometimes factory manuals.

Jun 06, 2008 | Chevrolet 1500 Cars & Trucks

2 Answers

Difference between Shelby/Ford and AC Cars?

The difference - huge. Carrol Shelby designed the power plant for the AC cobra, and the 69 AC cobra had the 426 emblem on the side, but the motor was actually a 429. Only year this was produced. To this day it is one of the fastest cars ever produced for commercial sale. The AC cobra was capable of going from dead stop Zero to 100 mph back dead stop zero in just over 11 seconds, and the story goes Mr. Shelby would tape a $100 bill to the visor on the passanger side, and tell the passanger if they could grab it as he went through the gears it was theirs - no one was able to boast this claim. The ford shelby fastback is a mustang that Carrol Shelby and Ford collaborated over. Shelby's 426 was put in the Ford Cobra, but the heavier, less aerodynamic Mustang had nothing on the AC cobra. The AC got it's body style from the old Austin Healy (I think - having a brain moment). Fundamentally, the AC cobra's are the american muscle car collecters holy grail. Everyone want's one, but no one can afford one - for an original 64 or 65 AC Cobra you can expect to pay $250,000. For the 69 with the 429 up the price to $500,000. There are a million kit car cobra's out there, and the owners act like they have something special - all they have is an over rated VW with a Cobra body kit. And boy do they get mad when you point out the imperfections!

May 18, 2008 | 2007 Ford Shelby GT 500 Convertible New...

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

270 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides