Question about 2000 Dodge Caravan

1 Answer

I have a 2000 dodge grand caravan when I pull the hood release it won't open

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Is the cable from the hood release tight or loose ? May be broken. You may have to remove front grill to get to latch mech.

Posted on Feb 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can the hood be opened without lever being pulled from inside? Lever isn't opening it from under hood and I think the battery is dead


It's very hard but if you crawl under car there is a cable you can pull that connects to the cable under your dash

Sep 30, 2015 | 2002 Dodge Grand Caravan

2 Answers

How far do we have to drive caravan to reset computer for inspection..


Your Dodge Grand Caravan, like all vehicles manufactured after 1996, has an on-board diagnostic system. When one of your Grand Caravan's sensors indicates that a system is not operating properly, it will trigger the vehicle's "check engine" light. Sometimes the cause of the error can be as simple as tightening a loose gas cap. In order to verify that the cause of the problem has been fixed, the computer on your Grand Caravan will need to be reset. This process is simple and takes less than 10 minutes.

Read more : http://www.ehow.com/how_7367264_reset-dodge-grand-caravan-computer.html

Things You'll Need

  • Adjustable wrench
Instructions
  1. Pull the hood release lever under the dash to release the hood.
  2. Locate the hood latch under the center of the hood and push the latch to the left. Lift the hood and open completely.
  3. Locate the battery on the driver's side of the engine compartment above the front wheel.
  4. Loosen the bolt on the negative battery cable using the adjustable wrench.
  5. Remove the negative battery cable from the terminal post. If it does not come loose easily, you may need to twist the cable end side to side until the cable end is free of the post.
  6. Reattach the negative battery cable end to the the negative post on the battery by pressing it firmly onto the post.
  7. Tighten the bolt on the negative battery cable until you are unable to move the cable on the battery post.
  8. Close the hood of the Grand Caravan.


Read more : http://www.ehow.com/how_7367264_reset-dodge-grand-caravan-computer.html

How to Reset Dodge Grand Caravan Computer eHow

Jun 10, 2015 | 2001 Dodge Caravan

1 Answer

Hood release on 1998 Dodge Grand Caravan isn't working


cable broken...replace. look under the top most fin of the grill and find wire to release...pull with pliers should release.

Apr 20, 2013 | 1998 Dodge Grand Caravan

1 Answer

1994 dodge caravan le hood release cable broke how do you open manually?


Most of these cable that break usually break at the connector under the dash. If this is the case you can still open the hood just find where the cable connects and pull this it should open the hood.

Feb 06, 2010 | 1994 Dodge Grand Caravan

1 Answer

Hood will not open due to the release lever on the inside on a 1993 dodge caravan tried pulling the cable but it still will not release the hood


Problem could be the other end of cable came loose from hood release latch under hood. You need to look through the grill closely and see if it did. I have had a few dodge caravans that this has happend to.

Dec 05, 2009 | 1993 Dodge Caravan

1 Answer

The hood release lever does not release the hood.


Do you have a new cable?? If not most likely there is a need for it it may be stretched out. You can grab the end of the cable that goes to the release (in the interior) with a pliers and pull it this will finish the cable and a new one will most likely be needed

Jul 11, 2009 | 1998 Dodge Grand Caravan

1 Answer

I need to change the alternator on my 2000 dodge grand caravan sport. Can someone please tell me how to release tension on the serpentine belt? Thank You.


I have to use a 15mm open/closed end wrench on the tensioner pulley. Use the closed end of the 15mm and pull toward you and use the end of a cresent wrench to use for additional torque. You can slip the belt over the fixed pulley (not the tensioner pulley). Give yourself more room by not using the hood bar and use instead a broomstick on the right side to prop the hood open. I recommend a goodyear gator belt too. Good Luck, you'll need it with a caravan. Its on the left side. its the easyest pully to see.

http://www.autozone.com/images/cds/jpg/small/0900823d8010b6d6.jpg


http://image01.shopzilla-images.com/resize?sq=140&uid=762102759

Hope this helps and please don't forget to rate.

Mar 12, 2009 | 2000 Dodge Caravan

1 Answer

Hood release


I had a '94 that some idiot at the oil change place left the dipstick laying on the top of the engine, which jammed the hood latch so it wouldn't open.

I happened to have the proper torx drivers for the grille to be removed and after that it wasn't much of a problem to release the latch.

DP

Sep 04, 2008 | 2000 Dodge Grand Caravan

3 Answers

How to replace serpentine belt for 2000 Dodge Grand Caravan?


Mine fell off twice so far once when going through snow and other was going through rainstorm had to use jack wrench to pry down and slip on belt which was hard to do and don't advise you to try. Ok the pulley directly under the alternator and in the middle of 3 other pulleys is the one that is the tensioner. To do this right use a 15 millimeter or 5/8 socket or open end wrench, the longer the handle the better so you can get good leverage maybe you have a pipe to slide over handle. There is a diagram of the way the belt goes on under the hood. I have a 2000 Dodge Grand Caravan

Jul 27, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2000 Dodge Caravan Logo

655 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...