Question about 1991 Ford F250

1 Answer

Transmission on my 91 Ford F250 wont go into reverse

Posted by on

Ad

1 Answer

First check your transmission fluid level, if its low then top it off. (Check it with the engine running and hot and leave the truck on for ten min, switch between gears to move the fluid around inside the tranny) If the fluid level is fine, see if the fluid is dark or burnt smelling, touch it and see if it has metal shavings in it. It may be worth your while to get a transmission filter change and flush out of the system. Flushing is different that just a fluid change, it pushes fluid thru the system to help clean it out. If this doesn't help then the reverse clutch inside the transmission is likely broken and in need of replacement, which is usually more expensive than getting a replacement transmission (from a junk yard)

Posted on Feb 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the overdrive solioned for a 3.0L 1991Ford ranger located inside valve body of transmission


91 Ranger - No OverDrive - Ford Truck Enthusiasts Forums

www.ford-trucks.com > ... > Small Chassis Trucks > Ranger & B-Series
Nov 18, 2006 - 91 Ranger - No OverDrive Ranger & B-Series. ... 1991 RangerAutomatic 3.0L 186,000 miles. Today the overdrive didn't work on my truck. ...However, if it is not a solenoid on vacation, you have probable failure coming down ... 2000 Explorer 5r55e transmission issues, drive and reverse.
Feb 5, 2013
A4LD - 4R44E and 4R55E
Oct 19, 2011
Transmission Bang Shifting - Overdrive Off Light Flashes
Jul 21, 2008
91 explorer trans porblem/ no overdrive
Nov 17, 2007
More results from www.ford-trucks.com

Aug 26, 2015 | Cars & Trucks

1 Answer

I have a 91 f250 4x4 e40D transmission. Had it rebuild, then slip it in. It shifts 1 to 2 ok. But not shifting to 3rd & fourth


Being a 91, take it back. But this really depends on who you had build it. Shade tree guy, your probably going to eat it. Garage, take it back and make them fix it.

Apr 28, 2015 | 1991 Ford F250

1 Answer

Transmission shifting problems


Yes ,you need to replace only ,after checking vacuum line that runs to it and make sure it's working correct

Apr 14, 2014 | 1998 Ford F250 SuperCab

1 Answer

I WAS PLOWING SNOW TODAY WITH MY 1990 F250 7.3 DIESEL AND THE TRANSMISSION QUIT WONT MOVE FOREWARD OR REVERSE WILL MOVE SOME AT 4000 RPM. LOTS OF FLUID NO BURNT SMELL IN THE FLUID


Only thing reverse and forward have in common are torque converter splines and pump. Is the fluid level high? This could mean pump and or converter has failed.

Jan 22, 2011 | 1990 Ford F250

1 Answer

Location of the back up light switch


The switch is on the drivers side of the transmission where the shift linkages are.

Jul 17, 2010 | 1991 Ford F250

1 Answer

1995 f350 E4OD transmission has no reverse


if it has no reverse this is a dead give away the reverse clutch is defective inside the transmission, in order to replace this clutch assembly u will need to remove and overhaul the automatic transmission, have been a Ford dealer tech for decades, know this for 100% sure.

Apr 25, 2010 | 1995 Ford F250

1 Answer

I have a 2001 ford f250 powerstroke diesel was driving and transmision started to slip drove about 3 miles and now wont move forward at all but reverse works fine


Some of the Ford transmissions actually have an aluminum gear which will go out somewhere around 150 to 200 thousand miles. OR it could be really low on transmission fluid.

Oct 18, 2009 | 2001 Ford F250 Super Duty Super Cab

1 Answer

My ford f250 goes into reverse sometimes, other times it doesn't move at all, drive works fine. Any ideas?


Check the linkage. Set the parking brake, and examine the transmission where the linkage connects to the actuator on the transmission, and have somebody operate the shift lever. Take note if the transmission is going into reverse or not and if the actuator on the transmission is always going to the same spot.

If this test does not reveal a problem, disconnect the linkage from the actuator, and move the actuator by hand to the reverse position. you should feel it fall into the reverse position. If it does fall into the reverse position, and the transmission fails to go into reverse, then take it to a transmission shop

Jul 14, 2009 | 1993 Ford F250

Not finding what you are looking for?
1991 Ford F250 Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...