Question about 2005 Peugeot 405

1 Answer

My 206 has no power

My 206 seems to be loosing power and dies when i change to lower gears why does this happen? and what is a calinoid???

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,098 Answers

Hi celinoid is part of the starter motor and would not cause this issue! most likely 1 of 3 things

The coil pack on these cars are really poor and dont like getting wet, you can normally tell if the car is chuggy and misfires.

the EGR valve " Exhaust gas recycler" valve this pushes unburnt fumes back through the engine to save fuel and emmissions, whe these go you normally get a warning light on the dash while the light is on the power is poor.

And finally the air flow meter or air mass sensor this regulates the air to fuel mixture if this is not working then the car either gets to much air or not enough. you can sometimes clean this part and it will work again.

Also check all the air pipes from the engine, if an air pipe is split or is taking in to much air then it will struggle to run correctly. be sure to check the undersides of the pipes.

Hope this helps
let me know if you need more info.

Regards

Dan

Posted on Feb 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a peugeot 206 allure I have clunking noise when changing from 1st to 2nd and from 2nd to 3rd but not when changing to forth or coming down the gear I have had a new gear box clutch and thrust


It could be a loose/failed engine or transmission mount. Look at the tranny rear mount and check the bolts and condition. Also check the bell housing bolts AND the bolts connecting the engine flywheel to the clutch pressure plate.

Jul 23, 2014 | 2003 Peugeot 206

1 Answer

Peugot 206 overheating problem


you could faulty themostat or engine coolant temperature sensor faulty do a code scan see what code come up.

Nov 15, 2011 | Cars & Trucks

2 Answers

Peugeot 206 GTi (Engine Squeeking Noise)


IF THIS IS NOT A SURPENTINE BELT,TRY THE P/S BELT TO SEE IF ITS LOOSE

Aug 20, 2009 | Peugeot 405 Cars & Trucks

1 Answer

My Peugeot 206 has a rattle


Sound like pre-ignition problem. pre-ignition is caused by running too low an octan fuel in the engine. The way octane works is simply the lower the number the faster the burn. If the fuel burns before the piston gets to the proper position in the cylinder it can cause what is call in the industry a ping. The remedy is to use a highert slower buning octane fuel or change the ignition timing. Mind you some engines with higher compression may not like the lower octane fuel even after adjusting the timing.

May 05, 2009 | 2005 Peugeot 405

4 Answers

1983 Mazda RX7 lacks power rough or no idle


Sounds like carb idle air or fuel jets are clogged.. Test pressure with a gauge to be sure. Float level and drop needs to be exact.. Operation of the whole carb relies on this. Probably why you are not getting any change in your air/fuel adjustments.

Apr 22, 2009 | 1983 Mazda RX-7

4 Answers

Free online version of haynes car manual


can you help my pug 206 when starting from cold engine seems like it,s only firing on three cylinders then when engine is hot seems okay but looses power on hills 206 automatic 1.4 engine if anyone can help

Apr 14, 2009 | Peugeot Liberte Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...