Question about 1998 Chevrolet S-10 Pickup

1 Answer

How do I remove drivers side door panel on 1998 Chevy S10 pickup to repair/replace window regulator?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

I think there are screws around the door handle on the in side that need to be taken off the the rest just pop out

Posted on Feb 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 Chevy Ventrue driver side window goes up crooked.


THE WINDOW IS OFF THE TRACK.THIS INVOLES REMOVING THE DOOR PANEL TO GET TO THE TRACK . UNLESS YOU ARE VERY MSURE OF WHAT YOU ARE DOING I SUGGEST YOU SEE YOUR REPUTABLE AUTO TECH .THE SPRING ON THE REGULATOR IS UNDER PRESSURE AND IF YOU ARE NOT CAREFUL YOU COULD INJURE YOURSELF. THIS IS NOT A NOVICE REPAIR HOPE THIS HELPS BILL

Dec 11, 2012 | Cars & Trucks

1 Answer

NEED TO REMOVE DOOR PANEL ON A 2004 CHEVY AVEO


Click the link below:-----Door Panel Removal?

--------
How to remove the door panel to install a new window regulator?
http://howtobyme.blogspot.com/2011/08/how-to-remove-door-panel-to-install-new.html


---------
Hummer H2 Door Panel Removal? http://technoanswers.blogspot.in/2012/07/hummer-h2-door-panel-removal.html Hummer H2: How to remove Front Door panel? http://www.howtobyme.blogspot.com/2012/07/hummer-h2-how-to-remove-front-door.html 2009 Hummer H2 Door Panel Removal http://schematicsdiagram.blogspot.in/2012/07/2009-hummer-h2-door-panel-removal.html

-----------
how to remove window motor on driver side door panel?
http://technoanswers.blogspot.com/2011/08/how-to-remove-window-motor-on-driver.html


-----------
ford explorer window motor, regulator and door panel removal?
http://technoanswers.blogspot.com/2011/02/ford-explorer-window-motor-regulator.html


---------
Keep updated for more help.

Nov 19, 2012 | Cars & Trucks

1 Answer

Where is the starter on a chevy s10 1998


http://www.ehow.com/how_6114322_replace-starter-chevy-s10.html Just replaced on my 96 a month ago this should help Mine was under the driver side of the truck

Nov 05, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

Power window failure, 1998 jetta vr6 glx, driver side does not work and passenger side only goes down from drivers switch. also how does the trim panel come off to work on the door


Remove the little door nob thingy for lock and unlock it just screws off,, Then you have 6 Allen key bolts around the door trim, remove those. Then remove the door handle cover just pops off you may need a small flat blade screw driver. you have two big screws Philips head screws in there... Then remove your speaker cover then the speaker, then remove the speaker, then remove the speaker bracket, then lift the door panel out. The motors and the regulators for your windows are **** door man makes a good unit for them i replace all 4 of mine... They are expensive Partsgeek.com is the best price i could fine. Looked for 2 years in junk yards and posted adds for replacement parts don't wast your time its damn near impossible. cost me about 500 for the 2 front window motors and regulators and I only replaced the regulators on the back windows I think they were about 50 a peace.

Jun 28, 2010 | 1998 Volkswagen Jetta

1 Answer

How do I replace the drivers side mirror on my 1998 chevy s10?


You would have to remove the door panel and then just unbolt the mirror from the inside.

Mar 20, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

How do I remove the driver side door panel?


door panel pulls straight out or slides, it is held on by plastic mollies they may break when you take it off be very careful not to break them but you can get replacements if needed. check Chevy dealership. there is also one or two screws one at handle, door panel should slide past door handle at angle.

Feb 16, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

Hi there ..I just got a driver side window motor,to replace my old one in my 99 Chevy Malibu..whats the steps to take to take off the old one and place the new ??


GM Malibu/Cutlass 1997-2000 - Repair Guide

Window Regulator And Motor Assembly
REMOVAL & INSTALLATION

Rear Door


4f4e997.gif
Fig. The rear window regulator is an assembly that consists of two pieces

NOTE The front window regulator is removed as an assembly with the door control module. Refer to the procedure outlined in this section under Door Locks.
  1. Remove the door panel and the water deflector.
  2. Remove the door glass (window).
  3. Detach the electrical connector, if equipped, or remove the window regulator handle.

To install:
  1. Install the window regulator.
  2. Place the regulator through the rear access hole into the door.
  3. Attach the electrical connector, if equipped, or install the window regulator handle.
  4. Install the rear side door window.
  5. Replace the door window assembly.
  6. Install the water deflector and the door panel.

Door Locks
REMOVAL & INSTALLATION

Door Control Module


882bea7.gif
Fig. The door control module contains the door locking system module and the power window system module
  1. Raise the window to the full up position.
  2. Remove the inside door trim panel. Refer to procedure outlined in this section.
  3. Pull off the plastic film water deflector enough to access the lock actuator.
  4. Remove the screws securing the door lock actuator.
  5. Remove the door locking system module nuts and bolt.
  6. Remove the door locking system module from the door.
To install:
Installation is the reverse of removal, but make sure to tighten the fasteners to the torque specifications listed:
  1. Door locking system module bolt-89 inch lbs. (10 Nm).
  2. Door locking system module nuts-89 inch lbs. (10 Nm).
  3. Door lock actuator screws-53 inch lbs. (6 Nm).

Hope helps (remember rated this) Good luck.

Jan 21, 2010 | 1999 Chevrolet Malibu

1 Answer

Fallen driver's side window


probably need a new window regulator. ebay. 93 to 98 should fit.

Section 01-05: Trim, Interior 1998 Villager Workshop Manual
REMOVAL AND INSTALLATION Trim Panel(s), Door Front
Removal
  1. Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
  1. swv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
    Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942) .




  1. If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel .
  1. Pull the shop rag back and forth to release the window regulator handle clip.




  1. Remove the three cover caps and front door trim panel screws.
  1. Remove the one front door trim panel capped screws from the door pull handle.
  1. If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
  1. Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124) .
  1. Remove the front door trim panel.
Installation
To install, reverse the removal procedure.
---------------------------------------------------------
Window Regulator, Power Front Door
Removal
  1. Disconnect the battery ground cable (14301) .
  1. Remove the front door window glass (21410) . Refer to the front door window glass removal procedure in this section.
  1. Remove the two front door brace bolts and the front door brace.


    415712f.gif

  1. Disconnect the front window regulator electric drive electrical connector.
  1. Remove the four front door window glass regulator track bolts.

    67b6136.gif


  1. Remove the three front window regulator electric drive bolts.
  1. Remove the front door window glass regulator track and the front window regulator electric drive (23394) as an assembly through the opening in the front door (20124) .
Installation
  1. Install the front door window glass regulator track and the front window regulator electric drive as an assembly through the opening in the front door .
  1. Install the three front window regulator electric drive bolts. Tighten the front window regulator electric drive bolts securely.
  1. Install the four front door window glass regulator track bolts. Tighten the front door window glass regulator track bolts securely.

Apr 29, 2009 | 1998 Mercury Villager

2 Answers

Chevy S10 Pickup Starter. Removed the two bolts


Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don

Mar 14, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Driver's side window regulator


I just replaced the regulator in my mother's 98 civic ex and didnt need any special tools. I do recommend replacing the glass run channels on either side of the window. I have replaced the regulator twice and it is still having problems as I haven't replaced the run channels. If not replaced very soon I can see myself replacing the regulator...yet again!

Aug 04, 2008 | 1998 Honda Civic

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

350 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...