Question about 1995 Chevrolet Blazer

1 Answer

My blaser will not take any fuel. - 1995 Chevrolet Blazer

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 303 Answers

There is an evap canister and a sensor for the vapor that system is not working

Posted on Feb 01, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 Chevrolet trail blaser shut off switch location

If your talking about the fuel pump, there is no shut-off switch. If your sure it is the fuel pump, check the fuel pump wiring for voltage and ground, engine cranking. Gray wire is voltage, black is ground. The pcm B fuse is in underhood fuse block. If good voltage and ground at the fuel pump with no fuel pump action or fuel pressure, suspect the fuel pump.

Dec 02, 2016 | Chevrolet Cars & Trucks

2 Answers

Location of shut off switch for 2004 trail blaser

Shut off switch for what ? Fuel pump ? This vehicle does not have a fuel shut off switch , if that's the switch your talking about !

Dec 02, 2016 | 2004 Chevrolet TrailBlazer

1 Answer

Just bought a used chevy blaser....iv'e been having dead battery problems, with possibly a bad alternater, it sounds like a bearing....but im wondering if i pushed a wrong button or somthing...

Check that the alternator is not working. This is common for a car to turn over and not completely start. The alternator is not charging the battery hence your electrical charge drains to low. If you are handy with a voltmeter, check that there is charge at the battery and if the voltage is higher when the car runs assuming you can start it again.

Feb 01, 2015 | Cars & Trucks

1 Answer

92 chevy s10 blaser 4x4 4.3 v6 starts but after it warms up it wont restart till it cools down

It is possible that the fuel pressure is low specially after the engine heats up and so it refuses to start. Rather than changing spares with a suspicion you must confirm the case before the part is replaced.So I think that the fuel pump must be checked, check the compression, timing and valve settings.

Dec 15, 2011 | 1992 Chevrolet S-10 Blazer

2 Answers

I need a diagram for a 96 chevy blazer fuse panel please?

my 1996 blazer wont shift in to 2-3 what can it be

Jan 21, 2010 | 1996 Chevrolet Blazer

1 Answer

Thinking about cutting floorboard to access fuel pump in 02 blaser.why didnt engineers do this?

the body and chassis are put together at different plants. the engineers are paid to design quick assymbly lowest cost. adding 1 more door acces may have soct 10 million dollars. they do not care how easy it is to replace after it is out of warranty. we added our own panel to our 2000 firbired. you can add one to you blazer. we just painted it and sealed it with boat rtv to keep out the water. it was alot easier than dropping the full gas tank, plus we had a dirt driveway.

Dec 31, 2009 | 2002 Chevrolet Blazer

1 Answer

I have a 89 chevy blaser with an electral problem

how to replace a tailgate switch for a 1989 chevy silverado blazer

Oct 27, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

98 chevy blaser is hard to start when is cold the fuel presure is fine

Check for the ground to the engine and to the body, chevys comes with a lot of grounds everywhere but the most for starting are the one on the engine and the one on the body, check for the correct gauge of the cables, fell the cables if they are warm whe you try to start, it supose to be a gauge bigger.
goodf luck.

Jul 08, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides