Question about Lincoln Mark VIII

1 Answer

How to replace upper controll arm on 95 lincoln mark vIII

Posted by on

  • tltutenjr Feb 01, 2010

    how do I get the air to release from the strut?

  • tltutenjr Feb 01, 2010

    thanx but how do I get the air out of the stru to remove the strut
    ?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

No tricks. first turn off air suspension by the switch in the trunk. lift the vehicle and you have one shaft(upper ball joint) that goes through the spindle. remove the bolt that goes through the spindle and tap lightly. the lower potion should fall away. remove the 2 bolts that go through the bushings to secure the "pivot point" of the arm to the frame of the vehicle. thats it. once you are done replacing the arm, do not allow the vehicle to be totally lowered. lower it with the jack until it sits about where it normally would and then turn your air suspension or air ride switch back on and wait. once thouroughly inflated, remove the jack.

Posted on Feb 01, 2010

  • Kori Policy
    Kori Policy Feb 01, 2010

    you can take the clip that holds it in and go to the air pump itself and push the clip in and pull the line out.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Best way to get at and remove vrcm on 95 lincoln mark viii?


My experience is with the Gen2 Marks--'97-'98, but these guys can help
http://www.markviii.org/htdocs/dc/dcboard.php
On the site do a search for VRCM.
do

May 01, 2015 | 1995 Lincoln Mark VIII

2 Answers

Is the code for the keyless entry anywhere other than the owners manual for a Lincoln Mark VIII?


It will be on the control module, but i don't remember exactely where they hide it, i think its in the trunk, either in the left wheel well or behind the seat

May 17, 2010 | 1997 Lincoln Mark VIII

1 Answer

There is a knocking coming from underneath the left side. i've replaced upper control arms and ball joints and lower balljoints, inner and outer tierods and swaybar links and still didn't solve problem


check to make sure the strut is good and tight up top. There's 3 nuts there. and i'm assuming it's the original air suspension. if it's been converted could a bad strut itself.

Jan 20, 2010 | 1995 Lincoln Mark VIII

1 Answer

RPM On Lincoln Mark VIII 1993 Idling up to 1500 -2000 RPM


Mine did same thing. I have a 95 Mark VIII LSC and took it to dealer after troubleshooting for two days. Turned out to be Throttle Position Sensor. With Diagnostic fee it cost about $350 including labor. Hope this helps- Mike

Jan 13, 2010 | 1993 Lincoln Mark VIII

1 Answer

Upper control arm bushing and upper Ball joint


dealer only or general mechanic to change these parts not really a do it yourself job .do you have a two ton jack ??? or the metal plates in floor to move the suspension to check it ---no take it to a garage trust me it will be cheaper and quicker in the end .you leave something loose or incorrectly fitted and with this heavy lump of detroit steel you could kill a lot of people .

Nov 18, 2008 | 2002 Chrysler Sebring

1 Answer

95 Lincoln Mark VIII Won't start up


try crankshaft position sensor. had one go bad on me

Oct 30, 2008 | 1995 Lincoln Mark VIII

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...