Question about Toyota Camry

1 Answer

Back weindow doesnt work. motor and switches are fine. i think its a grounding problem, but i dont know how to fix it.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

I have a '94 Camry that the passenger side back window would go down,but not back up. The problem was at the driver's door where the wiring comes from the body, inside the rubber wire loom there was a broken wire. Found it while installing new speakers and wire(had the door panels and kick panels off) Easy fix with soldier and soldier iron.

Posted on Feb 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshild wipers stop working


CHECK FUSE IF FUSE GOOD.HOOK A JUMPER WIRE TO GROUND AND GROUND WIPER MOTOR.TURN WIPER SWITCH ON IF WIPERS WORKS YOU HAVE TO FIX GROUND CONNECTION. IF WIPER STILL DONT WORK.REMOVE THE COWL COVER.TURN WIPER SWITCH ON TO SEE IF POWER GOING TO WIPER MOTOR IF YES.REMOVE WIPER MOTOR HOTWIRE IT.IF WIPER MOTOR DONT WORK REPLACE IT.IF WIPER MOTOR DO WORK CHECK FOR BINDING OR DAMAGE LINKAGES.IF POWER NOT GOING TO WIPER MOTOR AND FUSE GOOD.WIPER SWITCH FAULTY OR IT HAS BROKEN WIRE FROM SWITCH TO WIPER MOTOR.

Oct 04, 2010 | 2002 Toyota Avalon

3 Answers

My wipers will go on, but wont turn off, unless i turn my car off, or my ignition switch back one notch, and turn it back on...1984 oldsmobile delta 88..The switch has been replaced..Is there a relay for...


the relay is built into the wiper motor its called the pulse contol module and comes with a new wiper motor. make the wipers come on and then get them to stay on while wiper switch is in the off position, then tap the wiper motor and see if it turns off, if it does then u need a wiper motor assembly and be careful opening the hood some wiper arms will contact the hood when the hood is open and the wipers are on

Nov 27, 2009 | 1984 Oldsmobile Delta 88

1 Answer

My gas gauge issues and other similar electrical


Though these systems may be unrelated, there is one universal possibility that I can think of. This sounds like a problem with the electrical grounds throughout the truck.

Clean and tighten the ground cable on the battery, and make sure that the ground wires are tightly connected to the frame and engine block. After that, make sure that the ground connections for the systems you described are in good shape, and tightly connected.

Nov 20, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

I have a 1990 ford van e-150 and the blower motor for the heater doesnt work. I would like to know if it can be bench tested to make sure that it doesnt work before i buy a new one. Ive already replaced...


YES BLOWER HAS A 2 WIRE CONN GIVE IT 12 VOLT POWER FROM A BATT & A GROUND & IF BLOWER MOTOR IS GOOD IT WILL RUN IF IT DONT RUN BLOWER IS BAD NOT SHORE WITH WAY POWER OR GROUND GO REV. WIRES FROM BATT IF IT DONT WORK FIRST TIME

Sep 27, 2009 | 1990 Ford F150

1 Answer

1996 monte carlo windows will not go down or up from drivers side master switch and pass side switch will only go down. I know both switches are good, I pulled them and put in 1995 monte and they work fine...


it's in the circuit relay in the drivers master control pannel switch inorder to opperate these windows you actually have to short the power to ground inorder to move the windows up or down you need to repair/ replace the switch,
I had beat myself to death with that problem ,spent all winter taking my door apart to open and repair the door when the window kept coming out of it's tracks,Nice cars but boy never owned a chev that had as many problems as this one everytime you think you have it fixed another problem sneaks up and kicks you in the ***,good luck bud..

Jul 07, 2009 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Bad groind in subaru, HELP!


earth is making contact with the live at the bulb holder.remove and check.Make sure you have the right bulb in it.then replace the blown fuse.

May 30, 2009 | 2006 Subaru Outback

1 Answer

Front wipers stopped working


Try to run a ground test on the motor, If it gets power, then you neeed to replace the switch.. if it doesnt run with the ground test, then you need a wiper motor.

May 20, 2009 | 2005 Audi A4

1 Answer

Rear windows won't open with back controls


so we know that the motors and fuse is o.k.(opertes from driver switch).and the wiring to the motors are fine. the only thing is left is to check rear switch tosee if they are grounding . remove the swich and jump the termials to the motor if they work replace the switch. thank you

Jan 29, 2009 | Hyundai Motor 2002 Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...