Question about Honda Accord
I want to know detail and picture of symbol which are used in instrument cluster which is installed in honda acura mdx car .
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i use to work for honda and acura and from what i recall, the iphone is and or wasnt compatible with the bluetooth sytems(factory) i was haveing trouble pairing a custs iphone in a pilot, then was told its not compatible with that phone
Posted on Apr 06, 2009
Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.
Posted on Aug 22, 2009
Well, theres a sending unit/float in the tank that sends a signal thru
wires to your instrument cluster's fuel gauge. You should have an auto
electric repairperson determine where your problem lies. It's not often
the needle's just 'stuck' to where you could dislodge it. More often,
it's pegged overfull or underempty-signaling a shorted component
upstream of the gauge.
Similar problem and found the solution:
In the back of the gauge, where the 2 coils are located, there are very tiny copper wires which connect all the resistors/diodes. they each travel from within the coil and are soldered to 3 out of the 4 mounting pins. if any of these wires are shorting out or disconnected, the gauge will malfunction.
- take the gauge and flip upside down
- temp gauge has 1 resistor (blue) and 1 diode (copper)
- fuel gauge has 2 resistors, no diodes
- 1 wire should be attached to bottom mounting pin (letter E for EMPTY)
- 1 wire should be attached to pin holding both resistors (half tank)
- 1 wire should be attached to the stand-alone ground pin (no mounting bracket)
Hope that helps!
Posted on Oct 19, 2009
Tips for a great answer:
Dec 19, 2014 | 2003 Acura MDX
Aug 28, 2014 | 2003 Acura MDX
Jul 07, 2014 | 2009 Acura MDX
Jan 29, 2014 | 2005 Honda Pilot
Jun 06, 2012 | 2007 Acura MDX
Feb 16, 2011 | 2001 Acura MDX
Apr 06, 2009 | 2008 Acura Mdx
Mar 06, 2009 | 2002 Acura MDX
Dec 31, 2008 | 2005 Acura MDX
103 people viewed this question
Usually answered in minutes!