Question about 2007 Volvo V70

1 Answer

How do you turn off the 'Maintenance overdue' service light?

Posted by on

  • theweissguys Feb 01, 2010

    The key cannot be 'turned', it is a push straight in to start key (push button)


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 8,197 Answers

With the key in the igntion, hold down the odometer reset button. While holding the button down, turn the key to position 1 for 2 sec and the to position 2 untill the service light flashes 3 times. It can be tricky. You may have to do it a few times.

Posted on Feb 01, 2010

  • Jyackle5
    Jyackle5 Feb 01, 2010

    Put the key in to start like above just do not step on the break to start.


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Is service needed when "perform service" shows on the EVIC instrument cluster?

IS , (now that is a hard word to answer IS)
its just a silly light, the light glows as the results of the PCM brain
calculation, based on speed and time and load.
it be the same as an old car, and you brother took out the
operators guide and yell, hey BRO, that books says your oil is overdue.
and your bro is way smarter than any PCM. for sure.

the purpose is to prevent abuse of the drive-line.
most folks ignore maintenance so its like a virtual guilty conscience.
or as a nasty Nanny.

Oct 10, 2014 | 2005 Jeep Grand Cherokee

1 Answer

My 2004 chevy malibu beeps like if i turned on the alarm but beeps even when im in the car

I'm wondering if there is a battery to replace or something has appeared on the dashboard lights to indicate an overdue service or the 'check engine light'. Maybe the brake pads need replaced. Check your owner manual for issues or log into a Chevy Malibu user forum and find out what other people have done.

Smoke alarms will bleep if they detect the battery level is too low. I'm basing my answer on this type of preventative maintenance.

Apr 16, 2014 | Cars & Trucks

2 Answers

Maintenance light will not go out.

Need to take it to an Isuzu workshop or someone with computerised equipment. When the light comes on it is logged in the electronic brain as a fault or in your case an overdue service. This fault must be cleared from the brain before the light goes out.

Nov 11, 2009 | 2000 Isuzu Trooper

1 Answer

Will the check engine light come on if an oil change is overdue?

No the check engine light is only for emissions issues. If the oil change is very overdue (10000 miles overdue) then that can cause emissions problems and the check engine light.

Oct 30, 2009 | 2004 Audi A4

2 Answers

How do I turn off the scheduled maintenance light?

This procedure works for recent Volvo cars.

Oct 29, 2009 | 1998 Volvo C70

1 Answer

Oli indicator mileage reset

This is showing that your overdue for a sevice by 8,769. Depending on which service it will either say oil or inspection. With bmw's the order is of service is oil service .. inspection 1 ... oil service .... inspection 2. etc etc.

To reset the light the only tool you need is your finger. On some e46's there are 2 instrument cluster buttons (little rubber poles sticking out). If you press the left one with the ignition off you'll notice your mileage come up on the dash. This is the button you need to reset the service indicator.

With everything off,press and hold the same button and at the same time turn on the ignition to position 2 and wait a few seconds. It will then show the service and overdue mileage.Let go of the button and press and hold again until the 'reset' light flashes. Let go again and then hit the button once. Viola! The same can be done for resetting brake fluid light (clock symbol next to mileage) Instead of pressing and holding for the second time just press the button once to follow into a different menu for and the clock symbol will appear to be reset.

End of essay!

May 25, 2009 | 2003 BMW 325

1 Answer

Dear Sir/Madam: Would u pls let me know what possible causes, defects or problems would be when I get this sign on the panel: "SERVICE ENGINE SOON". Previously I wrote "CHECK ENGINE SOON". Sorry!!!!.

your maintenance service is overdue and that triggers the dash warning.  The mileage triggers these alerts an good maintenance shop can reset them.  Have your oil and other services done

Mar 28, 2009 | 2001 BMW 325

4 Answers

Maintenance info

Volvo V50 Maintenance Light Reset

1. Press and hold trip odometer reset button 
2. Turn ignition key to run position KPII (not the start position) 
3. Wait 30 seconds or until service light begins blinking 
4. Release Trip Odometer button 
5. Turn ignition to off position 

Oct 22, 2008 | 2006 Volvo V50

Not finding what you are looking for?
2007 Volvo V70 Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides