Question about 1998 Chrysler Concorde

1 Answer

Can you replace the just the bulbs in the 1998

Can you replace the just the bulbs in a 1998 Chrysler Concord headlight unit?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

Yes just the bulb.9006 is your low beam and 9005 is your high beam.They will go in from the rear.





















Posted on Feb 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the Drivers Side Headlight (bulb?) for 1998 Chrysler LeBaron (there is a coolant reservoir right behind the light assembly under the hood :(


Raise the hood and look at the headlight assembly from the top, you should see a couple of pins to remove and pull them up...the headlight assembly should come out. then just remove the plug and replace the bulb

May 26, 2014 | 2004 Chrysler Crossfire

1 Answer

Chrysler Sebring 2008 headlight assembly removal


some times headlamp units have a plastic retaining clip on the underside of headlamp, does the headlight move from side to side? try to pull the headlight back from the top of unit then lift up the headlamp unit, if not it could be the headlamp adjusters holding unit in place.

Dec 06, 2013 | 2008 Chrysler Sebring

1 Answer

Is there a headlight wiring loom for a chrysler voyager, or do I have to replace the entire headlight unit


Loom? The 1990 Models were mixed. Before that the whole head light was replaced. In the 2000 year models you need to locate the collar on the back of the head light, turn it counter clockwise and remove the bulb from the headlight assembly. Unplug bulb and replace then reverse the process to install. If you use the little machine that Walmart usually keep near the replacement bulbs in the Automotive section you can get verification of what type you have if your not sure. You will need to know the Year and model of your vehicle.

Oct 15, 2010 | Chrysler Voyager Cars & Trucks

1 Answer

How do i replace rear tail light bulbs and back up light bulbs on 1999 Chrysler concord XI


You will have to access the bulbs through the inside of the trunk either by removing the taillight assembly or just R&R the bulb.

May 25, 2010 | 1999 Chrysler Concorde

3 Answers

How do I replace a 2003 Chrysler Concord headlight bulb?


open hood, remove radiator suport bar that has the hood latch on it. in the center above the grill there are 2 10mm bolts and 3 plastic fasteners with a pin in the center of them, pull pin up and remove fasteners. there are 2 plastic fasteners on each side of center piece i broke them off and replaced the with fasteners with push pin from auto store. remove 10mm and 13mm bolts holding the center support bar and 2 long 7mm bolts holding headlight assembly lift bar up and set on engine. be carefull not to scratch fenters or anything else with th end of bar. there will be just enough room to remove bulb. after you've done it once it takes ten minutes 2nd time. i just did my wifes 2 hrs ago. thanks gary j.

Apr 18, 2009 | 2003 Chrysler Concorde

1 Answer

Low freon on a 1998 chrysler concord, where is the low pressure l


low refrigerent in a concorde was USUALLY caused by a leaky evaorator a big job at best and best left to a pro

Mar 28, 2009 | 1998 Chrysler Concorde

1 Answer

DHOW TO CHANGE OUT HEADLIGHT BULB ON 1996 CHRYSLER CONCORD LXI


For the bulb removal follow these steps.
-Open the hood and look behind the headlamp assembly with the burned out bulb.
-You'll see a black plastic ring about 2 inches in diameter, rotate this a quarter turn.
-Unplug the bulb, gently pulling the clip up to release the bulb.

Feb 05, 2009 | 1996 Chrysler Concorde

Not finding what you are looking for?
1998 Chrysler Concorde Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...