Question about 1993 Chevrolet Lumina

Open Question

Need to replace the heater core. 93 lumina euro. Where is it at, and what is the best way to get to it to replace it? also, is it very difficult to do? The part itself seems to be low priced. Just labor or time.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
cursealoud
  • 42 Answers

SOURCE: heater core replacement

If you replace the HEATER CORE, you might want to also replace the BLEND DOOR MOTOR as well while you're in there. These units tend to go bad very often in Crown Victoria's and Grand Marquis'. The job can be difficult but there are several ways to short cut it. You had to remove the dash board but if you have a 3 ft 2x4 or bar, you can prop the dashboard open after getting 75% of the screws out. The heater box is located behind the glove box. Take screws out from the top of the dashboard(right under windshield) and sides for easy access.

Posted on Aug 18, 2008

Ad
johnny5846
  • 379 Answers

SOURCE: 93 chevy lumina euro won't stay running

if you can check for spark when it wont start and fuel pressure and the service port , would be great information , otherwise pattern failure is ignition module and crank sensor (replace them as a set) , after cools off it will run again.

Posted on Dec 31, 2008

jmeyer847
  • 204 Answers

SOURCE: need to replace heater core in my 98' GMC Jimmy

Pretty difficult. With a manual and good weekend you can do this job yourself. I recommend having it done somewhere. Although expensive, its well worth it to have it done. 8-9 hours is about right. You need to remove things like the steering column and entire dash board, heater box and A/C components going into the box. Save yourself the hassle and bite the bullet on this one. You'll be glad you did. Thanks for using Fix Ya!

Sincerely,

JC

Posted on Jan 03, 2009

co7196
  • 3433 Answers

SOURCE: 93 chevy lumina crank sensor location

front of engine just about 11:00 over crank pullry

Posted on Jun 12, 2009

  • 149 Answers

SOURCE: How difficult is it to change a heater core?

yes, you gotta remove the dash,not too bad if your a jeep tech

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 93 Lumina Euro and am getting codes 42 and 35 from computer reading.


One problem is IAC it is sensor beside TPS (RPM).That is 35,42 really do worry for now.

May 04, 2017 | 1992 Chevrolet Lumina APV

2 Answers

The hose connection to heater core is it ridgid or not ?


no...most old hoses almost melt to the heater core connections due to the heat sometimes difficult to get off

Feb 14, 2011 | 1998 Chevrolet Lumina

1 Answer

Need to replace heater core on 1997 Chevy Lumina


If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core.
When a heater core leaks, a new heater core is installed or the old one repaired.
Heater Housing
  • The heater housing is usually under the dash and must be removed to gain access to the heater core.
  • Procedures for replacing the heater core vary with the year, make, and model of car. It threfore necessary to consult the manufacturer's repair manuals for the proper procedure for replacement.
f74-01.gif The heater housing is disassembled to get to the heater core. Heater Core
  • Remove the access panels(s) or the split heater/air conditioning case to gain acess to the heater core.
  • Remove the heater coolant hoses.
  • Remove the cable and/or vacuum control lines (if equipped).
  • Remove the heater core securing brackets and/or clamps.
  • Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing.
  • To reinstall the heater core, reverse the removal steps.
When the heater core leaks and must be repaired or replaced, it is a very difficult and time-consuming job primarily because of the core's location deep within the firewall of the car. For this reason always leak test a replacement heater core before installation.

Dec 23, 2010 | 1997 Chevrolet Lumina

2 Answers

How to replace heater core


Inspect/Replace If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core.
When a heater core leaks, a new heater core is installed or the old one repaired.
Heater Housing
  • The heater housing is usually under the dash and must be removed to gain access to the heater core.
  • Procedures for replacing the heater core vary with the year, make, and model of car. It threfore necessary to consult the manufacturer's repair manuals for the proper procedure for replacement.
f74-01.gif The heater housing is disassembled to get to the heater core. Heater Core
  • Remove the access panels(s) or the split heater/air conditioning case to gain acess to the heater core.
  • Remove the heater coolant hoses.
  • Remove the cable and/or vacuum control lines (if equipped).
  • Remove the heater core securing brackets and/or clamps.
  • Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing.
  • To reinstall the heater core, reverse the removal steps.
When the heater core leaks and must be repaired or replaced, it is a very difficult and time-consuming job primarily because of the core's location deep within the firewall of the car. For this reason always leak test a replacement heater core before installation.

Dec 11, 2010 | 1997 Chevrolet Lumina

3 Answers

Need to know where heater core is for 93 ford aerostar


Working in the passenger compartment, remove the six screws attaching the heater core access cover to the plenum assembly. Remove the access cover.

57a32ac.gif
Heater core and case

Depress the retainer bracket at the top of the heater core and pull the heater core rearward and down, removing it from the plenum assembly.

Nov 13, 2009 | 1993 Ford Aerostar Extended

1 Answer

'93 lumina euro,need to replace ignition switch in the column,broke the key off


if equipped with air bag. have a qualified shop or dealer perform this job.

Sep 30, 2009 | 1993 Chevrolet Lumina

1 Answer

93 chevy lumina crank sensor location


front of engine just about 11:00 over crank pullry

Jun 12, 2009 | 1988 Chevrolet Corsica

1 Answer

HEATER CORE


Going to your local public Library would be best at this point.
Also,,i should warn you that replacing the heater core is a difficult job for someone inexperienced, and even when you know what you are doing, it is difficult.

Jan 09, 2009 | 2004 Chevrolet Malibu

Not finding what you are looking for?
1993 Chevrolet Lumina Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...