Question about 1990 Dodge Spirit

Open Question

How do I remove the driver's side door panel in a 1990 dodge spirit?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

WardMesservy
  • 19 Answers

SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport

1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery


Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.

Posted on Jan 15, 2009

polarcycle
  • 1392 Answers

SOURCE: rear door panel on a 02 dodge ram quadcab

Should have to remove a couple of screws, unbolt the door handle, then lift upward. It is held in by slots.

Posted on Mar 07, 2009

  • 1114 Answers

SOURCE: Need info on how to remove driver side door panel.

I can give you generic info on how door panels are fastened and removed. I hope this helps. The outer perimeter of the panel is held in place on the sides and bottom by push-in fasteners that match holes in the door frame. These fasteners have button heads that attach to the back side of the panel, and the have ribbed shafts which are pushed in to the door frame holes. There are screws and/or bolts that secure the door arm rest and door handle molding to the frame. In some designs the screw head are concealed by small buttons, or by a piece of molding plate that pops out.
First step is to locate and remove all these screws. Next step is to place a screw driver at the edge of the door panel, between the panel and door frame and pry the panel away from the frame. There is a trim tool that is made for this task (relatively inexpensive) that you can purchase at the local auto parts store. The sides and bottom of the panel are popped away from the frame. After sides and bottom are loose, the top is released by pushing up to release the upper window molding from the frame. Be careful of wiring on the back side of the panel (electric windows, locks, etc.) Unplug all electric before you remove the panel totally.
Those nylon fasteners tend to break when the panel is removed, but they are replaceable (again, at your auto store). Just take one with you to match it up.
I hope this helps you!

Posted on Jul 26, 2009

  • 1986 Answers

SOURCE: 2005 Dodge Grand Carvan / Removing sliding door panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

dttech
  • 4803 Answers

SOURCE: 2006 Dodge Caravan driver side sliding door will

You probably have a problem with your Sliding Door Control Module. You will be money (and frustration) ahead if you begin this diagnosis by having your Body Control Module scanned.


Has this been helpfull? If so, please take a moment
to provide some feedback by rating my answer.

Posted on Jan 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the heater blower motor located on a 1990 dodge spirit?


usually on the passenger side of firewall .in the engine compartment

Sep 27, 2015 | 1990 Dodge Spirit

1 Answer

Where is the wiper relay on a 1989 dodge spirit?


Fuse box by driver side door side dash

Feb 14, 2015 | 1989 Dodge Spirit

1 Answer

How to replace door 94 dodge spirit


It does, just fing the proper page!

Jun 04, 2012 | 1994 Dodge Spirit

1 Answer

Where is the fuel pump relay located on a 1990 dodge spirit


left hand side of engine compartment on fender drivers side

Jan 08, 2011 | 1990 Dodge Spirit

2 Answers

Where are the bolts on the caliper located on my 1990 dodge spirit


on the back inside the wheel well side under rubber caps

Jul 25, 2010 | 1990 Dodge Spirit

1 Answer

1990 dodge spirit 64k miles only has second gear


check for trans fluid level or it may be vacume line to trans split or broken seeif some one can get the codes out of the trans computor

Apr 19, 2010 | 1990 Dodge Spirit

1 Answer

I'm trying to replace the passenger side view mirror and i cannot figure out how to take the door panel off


There are at least 2 screws, 1 at the armrest and one near the door handle that must be removed. They are usually under small plastic caps that have to be pryed up. Remove the Window handle if you have manual windows. Starting at the bottom of the door near the right corner with a flat head screw driver you need to pry the door panel away from the door releasing the push pins that hold it in place. These are difficult to remove and require patience and a little force to pry them out. Once the door panel is removed you should see whe 3 mount nuts/bolts that hold the side mirro in place and be able to access them so the old mirror can be removed and new one installed. Reverse the process to put everything back together.

Oct 31, 2009 | 1994 Dodge Spirit

1 Answer

1990 dodge spirit's electic fan won't turn on and cause overheating. no power is getting to the fan. ?


on the drivers side under hood there should be some relays. one will be to the fuel pump, also a auto shut down relay and ac relay and a fan relay, it is most likely the relay.

Jul 30, 2009 | 1990 Dodge Spirit

1 Answer

Power window wont go up or down but i can hear the motor running


You need a new window regulator.You will have to remove the door panel to replace it.

Jun 25, 2009 | 1990 Dodge Spirit

Not finding what you are looking for?
1990 Dodge Spirit Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...