Question about 1993 Chevrolet S-10

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 752 Answers

I woulsd try and change the o2 sensor located Under hood, passenger side, lower engine area, mounted in exhaust manifold ,and you have a catalytic convertor has it ever been changed i had an s-10 that always barely passed inspection even when brand new good luck

Posted on Jan 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What does the air pump on a 2001 Chevrolet impala do?

Air injection pumps or "smog pumps" as they are commonly called, are emissions devices used to clean up and aid in the burning of emissions such as carbon monoxide and hydrocarbons. These pumps inject clean air into the exhaust system to aid the catalytic converter in burning the excess emissions created at certain times of a vehicles operation.

Mar 20, 2013 | 2001 Chevrolet Impala

1 Answer

Losing compression in 3rd cylinder, will it effect 02 sensors?

It monitors your car's exhaust emissions, especially hydrocarbons and carbon monoxide.--------------------------------------------------------------------------
vas 5054a v19

Nov 30, 2012 | Ford Explorer Cars & Trucks

1 Answer

On a 2001 chevy s1o blazer,4.3 engine, what is the secondary air injection system, what does it do, and where is it located

it injects air into the exhaust to reduce emissions, burn off carbon monoxide and hydrocarbons. it is a system of tubes and pump, best bet is diagrams, which i cant post here, so suggest chilton or hayes repair manual $30 at auto stores with trouble shooting, diagrams, and directions.

Jun 09, 2012 | 2001 Chevrolet Blazer

1 Answer

1993 S10 Blazer with a Vortec Enginer V6 4.3L. Changed the Injector Assembly, Plinum Gasket, Plugs, O2 Sensor, Catalytic Converter. Still won't pass emissions test. What am I missing?

The problemis usually related to a EVAP problem. Such as a Vaccuum leak,bad EGR valve.The most common problem for these trucks is the EVAP canister in the rear of the truck or the vac lines going to or from it also the EGR valve gets clogged or stuck. If you get the truck scanned it should give a code then you will know where to look.

Apr 26, 2011 | 1994 Chevrolet S-10 Blazer

1 Answer

1993 S10 Chevrolet Blazer DID NOT PASS THE EMISSIONS TEST FAIL HYDROCARBONS, CARBON MONOXIDE passed NO ppm limit 1500 ,reading 0 , failed CO%limit 0.50 reading 0.84, failed HC ppm limit 90, reading...

what about the air filter is it clean ,silly question i know but you would be surprissed ,does this vehicle have one O2 sensor or two one after the cat as well or is it too old for two O2 sensors ,i know most europeon market vehicles didnt have cats till 1992 and most didnt have two sensors till around 2000 ,also check the two white or two black wires on sensor for 12v these are the heater feed wires for the sensors

Jan 03, 2011 | Chevrolet S 10 Cars & Trucks

1 Answer


Take it to a shop ASAP

May 12, 2009 | 1988 Dodge Aries

1 Answer

1986 camaro emissions problem- 6 cylinder stick

high hydrocarbons indicates head gasket(1 or both) leaking , carbon monoxide is a worn out catylitic convertor which both could lead to the oxy sensor getting a false reading

Oct 28, 2008 | 1986 Chevrolet Camaro

1 Answer

Removing a cat converter on a 1998 s10 blazer 4.3

You can safely remove the convertor as you asked but depending on your location your vehicle may not pass a safety or emissions inspection.

Sep 13, 2008 | 1998 Chevrolet Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides