Question about 1999 Toyota Tacoma PreRunner

1 Answer

My washer window washer stopping out om 99 toyota. the reservoir

My washer window washer stopping out om 99 toyota 4 runner . the fluid reservour is full of fluid.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 97 Answers

On the bottom of the reservour is a hose which is attached to a little pump which makes the washer fluid shoot out on to your windshield.it also has an electrical plug connected to it.sometimes by wiggling the plug it will start to work again,if not,make sure that there is power going to the pump.if there is power,your washer pump will have to be replaced.if there is no power,check your fuses. hope this information helps you with your problem. take care, manny

Posted on Feb 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 Toyota 4 runner 2 wd front wheel removal


Install front wheel bearing hub assembly on a ... - YouTube

? 8:42
https://www.youtube.com/watch?v=LQ-DGdt2J2U
Mar 11, 2014 - Uploaded by Andy Taylor
... Install front wheel bearing hub assembly on a 2003-2014Toyota 4Runner .... Pressing a 2005 and up Toyota Tacoma,4Runner, FJ Cruiser 2WD or 4WD ... How to Remove & Replace a Toyota 4x4 Manual Locking Hub ...
images for 99 Toyota 4 runner 2 wd front wheel removal

Nov 26, 2015 | Toyota Cars & Trucks

1 Answer

Which fluid do I top up with in the reservoir next to the converter under the bonnet? Toyota prius 2005.


Is a old school habit to top up fluids, if is low is , then there is a leak, or somebody serviced wrong, the reservoir that you are mentioned is call inverter reservoir, it uses long life toyota coolant, if the water pump leaks it is the one that will get low.

for the record, the only fluid that you refill is the windshield washer fluid.

Jan 20, 2011 | Toyota Prius Cars & Trucks

1 Answer

Hi there, how do you fill up the rear window wiper washer water for a toyota estima van 2003? Thanks, Eileen


The rear washer fluid comes from the main reservoir under your hood for the front window. Sometimes the rear will not work because it is not filled high enough, hope this helps

Jan 19, 2011 | Toyota Previa Cars & Trucks

2 Answers

Power door locks for 1999 toyota 4runner unlock but do not lock on inside switches or remote


I have the same problem I can unlock my toyota 99 4 runner but does not lock on inside switches or remote.

just found out about it today.

Feb 16, 2010 | 1999 Toyota 4Runner

2 Answers

My 2004 toyota 4-runner rear window heater and wipers stopped working


If they stopped at the same time,...Probably a bad fuse. If not, follow wires. Wire harness may have come unattached.
If at different times, Your warrentee probably just ended.

Oct 10, 2009 | 1996 Toyota 4Runner

1 Answer

Mercury villager 1994 washer pump not working


the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal
  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

    Installation
To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Sep 09, 2009 | 1994 Mercury Villager

2 Answers

99 toyota 4-runner low idle, and hard start in cooler weather


Take ur suv to the nearest high point...Get out of the suv, put it in neutral..and firmly push off of cliff. Problems solved. report it stolen the next morning.

Mar 10, 2009 | 1999 Toyota 4Runner

Not finding what you are looking for?
1999 Toyota Tacoma PreRunner Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...