Question about 2006 Pontiac Montana SV6

Open Question

I have a 2006 Pont. Montana SV6...I am getting the code P0496. What do I need to do? Also when I try to start the van, if I dont use the accelerator, it wont start and stay running. Lately when I get fuel, if I leave it running, it will start surging in the idle and die. My check engine light has also just came on about 1 week ago, so I let Advance check my codes and they said it pulled up P0496. HELP

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock

For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Posted on Feb 14, 2009

  • 1 Answer

SOURCE: real right turn signal light - Pontiac Montana SV6 2005

If the 2005 Montana is similar to the 2001 Montana, I have a solution. First you'll need a hexagonal wrench (the 6-sided L-shaped wrench). The tail light assembly is held on by two screws. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I also had to use a conventional adjustable wrench to get the leverage to turn the hexagonal wrench, because the screws were in there pretty tight. Once you remove the two screws, the whole tail light assembly should come off. Mine required a little force and I had to play with it a bit, but it came off without a lot of work. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Once you get the tail light assembly off, you'll have to take apart the assembly that actually holds the lights. No tools should be required. It's held on by four plastic catches. Just undo the catches (easier said than done, but still not too tough) and it comes apart. Then you can pop out the old light and pop in the new light. Then re-assemble. For me, it went back together much easier than it came apart.

Posted on Jan 03, 2009

  • 1 Answer

SOURCE: clunking from front end

CHECK FRONT STABILIZER LINK KITS FOR PLAY.
ONE ON EACH SIDE ATTACHED TO STRUTS.

Posted on Apr 26, 2009

  • 148 Answers

SOURCE: winding noise and vibration when driving on front right tire

you could have more than one problem the vibration accelrating maybe an inner cv joint ,if you just had the tires replace and an aligment done they should have checked the front end for worn out ball joint and tierods but the wheel bearing may not have any movment but can still make noise

Posted on Jul 13, 2009

wilsodfarm
  • 986 Answers

SOURCE: Changing the front brake pads on a 2006 Pontiac Montana SV6

Use a z clamp,Or us big azz pliers,Or use a hammer handle and put one of the old pad in and put the hammer handle in the and twist it will work.I hope this helps

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buttons don't work to open rear passenger door


You need to be more clearer with your question...not sure what you mean by "hand wire comes outside van"??? also not sure what you mean by "get buttons to open door" are you talking about the sliding side doors on your 2006 Montana.if so clean off the contacts they are located on the door post also on the door itself..hope this helps

Sep 29, 2014 | 2006 Pontiac Montana SV6

1 Answer

2008 Pontiac Montana S6 Won't Start.


Sounds like the anti-theft/alarm system was triggered.
Have you tried locking and unlocking the driver door with the key to disable the alarm ?
And you need at least 12 volts to crank the engine so the battery may need to be charged up first.

Feb 24, 2014 | 2006 Pontiac Montana SV6

1 Answer

How do I remove the front console cupholder tray on my 2006 pontiac sv6 van? Something fell behind it and I need to retrieve it.


There should be 4 access screws holding it down locate them in the console and it should come right out good luck hope this helps

Jul 17, 2011 | 2006 Pontiac Montana SV6

1 Answer

Lost engine power on the road, had to be towed to gas station, then van started again. Guy said it may be fuel filter.


fuel pump could be going bad, i would try filter first(would replace anyway if needs new pump)

Nov 11, 2010 | 2006 Pontiac Montana SV6

2 Answers

2006 montana sv6 remote starter causes alarm to go off


I have the same problem. Did you figure it out? It happened for me after the battery went dead and I changed it... R

Dec 07, 2009 | 2006 Pontiac Montana SV6

1 Answer

2005 Pontiac SV6 Montana key fob unlocks doors but will not lock


For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Feb 12, 2009 | 2006 Pontiac Montana SV6

Not finding what you are looking for?
2006 Pontiac Montana SV6 Logo

Related Topics:

275 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...