Question about 2004 Nissan Altima

1 Answer

Engine malfunction warning light on,noticed black fluid of some kind coming from exhaust pipe? nissan almera 01 reg. driving fine,no unusual noise ect.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 86 Answers

Have some one scan your car for diagnostic trouble codes. There is an emmision control fault that should be taken care of or it could lead to further problems. The fluid coming out of the tailpipe is normal. Gasoline has a certain percentage of water in it and what doesn't get evaporated comes out the taipipe.

Posted on Jan 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driving noise, not from bearings


it could be center bearing, if its going bad it can also cause a vibration, make sure you have sufficient fluid in the diff as well, you can also get a noise and vibration from collapsed motor or trans mounts

Oct 13, 2015 | 2005 Nissan Murano SE

1 Answer

Nissan gearbox


You have a failed transmission.

Mar 12, 2014 | Cars & Trucks

1 Answer

Nissan Almera 2000 X reg. Engine management light keeps coming on?Can someone suggest a code reader to reset?


When that light comes on, it is telling you that you have a sensor that is operating out of range and you need to resolve this issue. To simply reset it will accomplish nothing, because as soon as the sensor exceeds it's allowable limits again, the light will come right back on again. Have it properly diagnosed and repaired that way the light will stay out and your vehicle will operate as it was designed.

Here it is the one, Memoscan U380 scanner is a kind of auto device for reading and erasing trouble code in vehicles, sometimes called car reader. Though so small, light and handy, which is dynamic and fashionable in design, competitive in price and easy to use.

May 10, 2012 | Cars & Trucks

1 Answer

Almera


What did you use to clean the MAF?
You may have damaged the sensor.
I would suggest a used MAF assembly be installed and use only approved cleaners next time and be gentle when cleaning electronics.

May 17, 2017 | 2005 Nissan Almera 1.6

2 Answers

Nissan Almera Air Con Advice


It may be low on refrigerant if the pressures are to low, the compressor will not engage.

Jul 31, 2009 | 2000 Nissan Altima

1 Answer

Engine warning light on Nissan Almera 03


its very simple. You can see a black hose from the engine which connects the metal pipe. just remove it and you can see three gold color pin from the metal pipe. scratch that pins using a salt paper and fix it. Now check whether you get started or not. Thanks.

Jul 03, 2009 | 2003 Nissan Altima

1 Answer

1997 camry all warning lights on for a while


Just tell them of the smell. They will start by checking all fluids to see if any are low. And do a visual inspection to look for stains or whatever the smell was from. Do you know what a bad catalytic converter smells like? It is described as sulfurous, like rotten eggs smell. This part is in the exhaust piping, and used to clean pollutants from the exhaust.
Now about those warning lights in your dash: those red lights are supposed to always come on when the key is turned to on and then to start. They turn on with key on, and then soon as engine starts (or right after-within a couple of seconds) the warning lights should all turn off. So I'm not sure if you just hadn't noticed them before, or what. Do they seem to stay on for an extended period of time? The only reason a red light would stay on after engine starts, would be a warning that something not right. (Like if the "dripping oil" light would stay on, that is a danger, cause that is your engine oil pressure. If that light stays on, you lost oil pressure, and meaning shut engine off immediately before damage occurs.)
So the warning lights come on as a visual check that those bulbs are good, just in case a warning is needed. Then engine starts and all warning lights should go off. See? Good luck, probably not a big problem, but good you check it out.

Mar 18, 2017 | 1997 Toyota Camry

1 Answer

Nissan almera 2002 1.5 twister


you need to have someone like auto zone or your favorite repair shop scan the computer for codes and post them back here so i can help you further Auto zone will do this free of charge in most cases please rate -Jeff

Sep 13, 2008 | 2002 Nissan Altima

2 Answers

Nissan Almera


The malfunction indicator is not lighting up initially.

Jun 07, 2008 | 1996 Nissan Altima

Not finding what you are looking for?
2004 Nissan Altima Logo

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...