Question about 2007 Toyota Yaris

Open Question

Engine warning light showing on aygo 2006. Electronic tester showed defective lambda sensor, Replaced lambda sensor but still shows after a few miles

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 345 Answers

SOURCE: emission warning light

diagnostic check other wise you are just guesstimating!!

Posted on Oct 09, 2008

  • 49 Answers

SOURCE: 2004 Camry XLE fuel gauge problem

Check online in other forums of this particular issue. Others may have had the same issue and have found answers through other sites online. Sound like a bad sending unit "fuel gauge sensor". Unfortunatly, it may be a requirement to remove the fuel tank to gain access to this fuel sensor. If you dont have the means to repair this problem you can always keep track by the mileage that you put on your vehicles tripometer. I know thats a pain but it wont cost you any money until you choose to have the repair done.Estimate your mpg's and the size of your fuel tank by the gallons, and multiply the two. Be sure to keep track and have enough fuel not to run out! Its always better to keep half a tank than an eighth of a tank!

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: Warning lights on a 2006 toyota rav 4 32,000 miles

I had the same problem. A computer check showed that the emission system was having difficulty. The catalytic converter had to be replaced. The car had under 80,000 miles on it so it was covered by a warranty (State law? Federal law?).
My battery was also dead. That was replaced free too. It had a 7 year warranty.
I do NOT purchase extended warranties.

Posted on Jun 26, 2009

  • 593 Answers

SOURCE: Code P0174 05 Corolla

I don't show any po174 for an 05 corolla. But I do show a po741, if thats the code you're getting.
It means theres a problem with the torque converter
clutch system. It could be the tcc solenoid. Either way, it's related to what you just had done.
Good luck.

Posted on Feb 01, 2010

  • 64 Answers

SOURCE: i have a toyota premio

Good Day qits81, if your vehicle does not do anything funny while running it is nothing to worry about. Under normal operating conditions the engine control unit runs an automatic system diagnosis program to ensure that the engine runs at an optimum. As soon as the engine control unit received "feedback" from the sensors and all is o.k the light switches off. If there is a problem with one or more of the systems the check engine light will stay on to warn the operator that they need to have it checked out.

Posted on Nov 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Aygo dashboard signs


that little orange light is the check engine warning light.
that means there could be something significantly wrong
the light is turned on by the computer in the car, the computer was told by one or more of the electronic sensors that something is not correctly working.
Take you car in a service repair company or the dealer and have the "engine check light diagnosed" they will tell you afterward what could be not working correctly.

May 21, 2014 | 2006 Toyota Aygo 1.0

1 Answer

Intermittant engine management light comes on after approx 250 miles when checked at dealers no fault showing but lambda sensor triggered warning now getting no abs or slip contol warnings on dash could...


abs problem will be a wheel sensor. if speedo working its not the pass side one. now for the lambda sensor. if you are traveling at 70 mph for 250 miles at a time this will over heat the sensor over time. as its a 2007 and normal running over time to replace them is 10 years. most that do over 500 miles a day would need to change them with in 2 to 3 years.

Mar 12, 2014 | 2007 Nissan 350Z

1 Answer

2006 Nissan Murano Problem


What are the fault codes you now have, do not assume it is the same problem causing the rough run. I suspect that something was not done right during the overhaul/rebuid.

Feb 09, 2012 | 2007 Nissan Murano 3.5

2 Answers

My nissan ad van 2006, Y11 type is constantly showing handbrake warning light... the fluid level is on max.. the light goes off when the socket of warning light is removed from the brake fluid...


Hi, the level sensor in the reservoir has failed. Sometimes you can free it up by tapping on it. Otherwise, you may have to replace the reservoir/sensor.

Oct 12, 2011 | Cars & Trucks

1 Answer

Check Egine Light Stays On


Well if the sensors are defective the garage should warranty them,unless they are aftermarket products
then the warranty isn't so great.
If the shop that did the work determines that the sensors are a-ok then there may be a problem with the ECU or the circuit.

May 04, 2010 | 2000 Mercedes-Benz E-Class

2 Answers

Engine warning light says lean bank 1 low.


generally aftermarket parts are made from the original toyota models so it is doubtful that is the problem. There may be a short in the wires that are causing the sensor to burn out. I would suggest first taking to your local auto parts store and have them scan the ECU for the problem. I hope this helps. Please rate this Thank you

Mar 01, 2010 | 2007 Toyota Yaris

2 Answers

My Audi A2 1.6fsi shows fault code relating to knox and lambda sensors are the two connected in any way. Mechanic said that it was one of the lambda sensors first now he is referring to a knox sensor. I...


The Nox sensor fits after the catalyst (non FSi models had a rear lambda) the lambda on your car is near the engine and has 5 wires because it is a broardband type.
The Nox sensor is a common fault on all FSi models

Nov 18, 2009 | 1996 Lexus ES 300

2 Answers

Peugeot 206 1.4lx misfiring engine light flashing run fine for a few days then start problem again diagnostic showed too many faults to determine problem


i would reset the light and start over. it sounds like things were unplugged for testing purposes. dont let it intimedate you. let me know what else you find. you can e mail me at iambanshee74@yahoo.com

Nov 04, 2009 | 2005 Peugeot 405

1 Answer

Engine light and emmisions worshop on dash


You will need to have another code scan done. A faulty glow plug will certainly show up on a scan, but should NOT bring on the engine MIL light. Erase all faults showing at present. This should extinguish the engine light. Thin start and stop engine a number of times until the light comes back on. This will re boot on-board computer. Do another scan and the fault should show up. If possible do a live reading, paying close attention to the (oxygen sensors) lambda units
Best of luck
John

Oct 03, 2009 | 2005 Volkswagen Passat

Not finding what you are looking for?
2007 Toyota Yaris Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...