Question about 2002 Pontiac Grand Prix

1 Answer

I am trying to get an engine out of a Grand prix can't find all bolts between engine and transmission got 4 from the top

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

There should be 2 more on the bottom, an what about your motor mounts did you unbolt them, sumtimes the starter bolts hold it on, Oh this one time i had to take tranny pan off to get 2 bolts that were in behind... haha front wheel drive, pain in the ***...

Posted on Jan 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 08 grand Prix the knock sensor has gone bad (bank 2) it's in between the engine and transmission, is it possible to replace it without removing the transmission?


What code did you pull ? How do you know it's bad ?
Remove the transaxle. Refer to Transmission Replacement for the 4T65-E transmission. Drain the cooling system. Refer to Cooling System Draining and Filling . Remove the bolts (2) from the knock sensor heat shield (1). Disconnect the knock sensor electrical connector (3) from the knock sensor.

Sep 14, 2016 | 2008 Pontiac Grand Prix

2 Answers

Where is crankshaft sensor located on a 1989 pontiac grand prix with a 2.8l v6


Will be on the side of the engine block.Held on with one bolt that screw into the block, remove bolt and sensor slide out.

Jun 18, 2010 | 1989 Pontiac Grand Prix

1 Answer

How do you remove the oil pan on 2001 grand prix


Remove the motor mount bolts on both sides. Using a jack & wood block, jack the engine high enough to allow the pan clearance enough for removal. Use wood blocks(4 by 4) at motor mounts & lower engine mounts onto the blocks. Lower & remove jack & block at jack. Remove pan bolts & carefully using a large pry bar or common screwdriver pry the pan away from engine . Good luck!

Apr 01, 2010 | 2001 Pontiac Grand Prix

2 Answers

How do you change the waterpump on a 3.8 liter grand prix? what parts have to be removed?


drain the coolant
remove the overflow bottle 2-10mm speed nuts
remove the drive belt
remove the water pump pulley(center of the engine and no groves)
4-8mm bolts
remove water pump bolts 4-10mm 3 of the 10mm bolts are on top and the other is under the pulley flange in the center
4-13mm bolts are on the side(they are long bolts they also go through the front cover)
take a hammer and screw driver and tap the pulley flange to break the pump free
clean the old gasket off
and install the new pump
and reassemble
open the bleeder screw on the thermostat housing
fill the rad
close the bleeder screw
start the vehicle and run to operating temperture
check that you have GOOD HEAT(HOT)
hope this helps

Jan 21, 2010 | 2005 Pontiac Grand Prix

1 Answer

Thermostat for 2007 grand prix Where is it located?


follow the top radiator hose to the engine,it connects to the thermostat housing,remove the hose,and two bolts holding down housing

Jan 08, 2010 | 2007 Pontiac Grand Prix GXP Sedan

2 Answers

Where is the drain plug for the automatic transmission fluid on a 2000 pontiac grand prix gt 3800 engine


transmissions do not have drain plugs u must remove the trans pan assembly slowly from one side to the other and have a large container under it to catch all of the fluid then replace the trans pan gasket

Nov 11, 2009 | 2000 Pontiac Grand Prix

1 Answer

Can I take a super charger out of a Grand Prix GTP and fit it on my Grand Prix GT 3.8L V6?


Well, the short answer is "yes". But - it isn't nearly as simple as just bolting the supercharger onto the intake and VOILA!, now you're supercharged. The procedure that you're inquiring about is commonly referred to as a "top swap", and there are numerous parts you will need for both engine as well as the transmission. Why the transmission? Because the GT and GTP use different gear ratios and the GTP has a 4T65HD as opposed to the 4T65E that is in the SE/GT. You will also need to have the PCM reprogrammed to accomodate all of these changes.

HERE is a great website that has a ton of very useful information, regarding this and many other Grand Prix topics.

Hope this helps and thanks for using FixYa!

Oct 20, 2009 | 2000 Pontiac Grand Prix

2 Answers

Want to see if transmitions are the same


all you have to do is call the dealer auto parts dept.or a auto dismantling yard.They will tell you what years and model certain parts will fit

May 25, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
2002 Pontiac Grand Prix Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...