Question about 2000 Honda CR-V

1 Answer

How can I repair the digital clock in a 2000 Honda CR-V? I hear the repair is rather simple. Clock just died.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 273 Answers

If it isn't the fuse then it is an internal issue. The easiest fix is it is solder on the the thin resistors on the circuit board (sometimes the soldering goes "bad"). Open up the clock and look at the resistor soldering, if they look cracked then they need to be re-soldered. I offer a convenient repair solution at, lifetime warranty and I repair more than just the resistors if needed.

Posted on Feb 21, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is fuse for clock on 1989 honda crv

its more like the clock has died

Jun 10, 2014 | 1998 Honda CR-V

1 Answer

On a Honda CRV-2000 clock module (working intermittently, no fuses are out), there are 4 connections: B+, IG, LI, and GND. I'm assuming the B+ is a fused connection from the 12V battery. What are the IG...

Ignition and headlight illumination (clock should dim when wired to IG/+). The clockshould be bright with it disconnected and dim with it connected to +/IG. If it is dead in all cases, I offer a repair service, check out

Feb 28, 2011 | 2000 Honda CR-V

1 Answer

I have a 1998 Honda cvr and the digital clock is out of can this be repaired, because it is not a fuse.???

Those clock's can not be open and repaired, dealer part, only fix is replacing it.

Nov 11, 2010 | 2000 Honda CR-V

1 Answer

Where can I get a digital clock for my 2000 CR-V that doesn't cost $150 (dealer price)?

have you tried a cheap $1.50 clock from a discount store and some two way tape

Aug 25, 2010 | 2000 Honda CR-V

1 Answer

Honda HR-V clock doesn't illuminate until the flap covering the time set buttons is pressed. Also what does the reset button do?

This is a standard symptom of the clock going bad internally. The reset button should set the time to the nearest hour. In any event, I offer a repair service and have the removal instructions at my site, check it out!

Jun 24, 2010 | 2000 Honda CR-V

2 Answers

How do you change the clock on a 2001 honda crv

The clock removal instructions are available at
If you have a defective clock, we offer a very reasonable repair service with a lifetime guarantee.

Subaru Forester 1998 - 2002
Subaru Impreza/WRX 2002 - 2005
Toyota 4Runner 1996 - 2002
Nissan Pathfinder 1996 - 2004
Honda CRV 1996 - 2001
Toyota Tacoma 1995 - 2004
Toyota Rav4 1996 - 2000
Toyota Land Cruiser 1996 - 2002
Toyota Camry/Corolla 1996 - 2004
Lexus ES300, GS300 1997 - 2004
Saab 9-2x 2004 - 2006
Toyota Matrix 2003 - 2008
Toyota Sienna 1999 - 2003
Ponitac Vibe (Voltz) 2003 - 2008
Suzuki Aerio, Vitara mid 2000s

May 31, 2010 | 2001 Honda CR-V

1 Answer

Time clock has stoped working


Below are the removal instructions from my website I also offer a very reasonable repair service.

1997 - 2001 Honda CRV Clock removal Instructions
The vent bezel assembly needs to come out prior to clock removal.
Follow these 4 steps
1. Using a wide,thin blade such as a putty or butter knife, pry the
assembly up a little at the bottom until it pops out and slightly.
2. Pull the bottom out as it clears, and the top of the vent bezel
assembly will follow.
3. Once you have the vent bezel out, remove the electrical plug from
the clock.
4. Unscrew the two phillips screws that hold the clock in place.

Mar 21, 2010 | 2000 Honda CR-V

2 Answers

The clock doesnt work. it doesnt light up. how can i fix it?

Sounds like your clock is dying. This is typically an issue with the clock itself. This is very common with many Subarus, CR-Vs, Pathfinders, 4runners, etc. The good news is that it can be repaired for a reasonable rate, and a lifetime guarantee. Check out

Jan 26, 2010 | 1998 Honda CR-V

1 Answer

My honda crv 1999 clock broke how to take the clock out .

I have the removal instructions and repair solution at:

Oct 05, 2009 | 2001 Honda CR-V

3 Answers

Honda CR-V Clock

If it is not the fuse then it is something internal. I can fix it for far less than the dealer, check out

Jun 11, 2008 | 1999 Honda CR-V

Not finding what you are looking for?
2000 Honda CR-V Logo

Related Topics:

1,163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides