Question about 1992 Mazda Protege

1 Answer

When put into drive the car shakes and stalls. It

1992 mazda protege. When put into drive the car shakes and stalls. It starts right up and runs smooth in park. Also, it runs and does not stall or shake in reverse.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Posted on Aug 18, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalls in park


Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel.

Clean / replace air filter.
Check ATF at level ground. Top off to MAX level.

Use starting fluid to aid starting.

Nov 20, 2013 | 1992 Mazda Protege

1 Answer

Code says system running too lean Bank1 and at stoplights I have to put car in neutral or it will stall


Lean Bank1 can be attributed to a faulty oxygen sensor or by unmetered air entering the system. A comon problem with the protege is cracks in the plastic air intake hose after the MAF which sucks air in that is not registed by the car and thus make it run lean and idle poorly
.
Another comon problem causing rough idle is the EGR valve being stuck because of carbon deposits, this will usually throw an EGR related check engine light but not always.

Feb 11, 2013 | 2000 Mazda Protege

1 Answer

My 1994 Mazda protege runs well while driving, but gets the shakes when we idle. Is this a huge thing I should have address right away?


Check the rubber tube between the throttle body and the air filter housing it may have a crack in it and it sucking to much air at idle.

May 20, 2011 | 1992 Mazda Protege

1 Answer

Engine stalls when shifting into any drive gear.


It sounds like your idle air control valve could be going out on you.  The extra stress from being in gear can cause the car to stall out if the IAC valve isn't opperating properly.  The IAC is attached to the throttle body and is normally held on by two screws.  IAC valves are relatively cheap from AutoZone and easy to replace.  That would be my best guess based on your description.  Good luck and let me know if you have any other questions.  Thanks for an honest rating and for using FixYa!

May 24, 2009 | 1993 Mazda Protege

3 Answers

2001 mazda protege keeps stalling


my 2001 mazda protege starts hard, idles low and high at various times (never normal) and it acts as though its going to stall at all times. sparks and wires are changed no help, changed air filter no help. any idea on what to do?

Mar 26, 2009 | 2001 Mazda Protege

2 Answers

1992 Toyota Camry Rough Idle


start by pulling hose off egr valve see if idles smoother almost instantly

Mar 17, 2009 | 1992 Toyota Camry V6

2 Answers

2000 Protege keeps stalling


more then likely its you mass air flo sensor to check it locate it on backside of motor n tap while car running if it stalls theres ur problem

Jan 18, 2009 | 2000 Mazda Protege

1 Answer

Engine bogs and stalls


Check the air filter hose. My '99 Protege was idling rough and would sometimes shut off. The air filter hose was cracked half way around. I replaced it (easy just loosen two hose clamps and pull out the sensor) and the car is running fine.

Dec 27, 2008 | 2000 Mazda Protege

Not finding what you are looking for?
1992 Mazda Protege Logo

1,548 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...