Question about 1993 Buick Park Avenue

1 Answer

My car wont start when we put a screw driver on the starter solonoid it cranks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

The electrical ignition switch is at fault then

Posted on Jan 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Can my battery amps be causing my 2004 dodge status not to crank? Its abattery.


the cold cranking amps rating can be found on the battery sticker. the higher the number the better it is since amperage is the flow of current and will withstand longer battery use by all electrical and electronic components on a car. amperage of a battery is also affected by temperature so if the battery cca rating is low and you live in cold weather it will cause slow cranking. your starter is only as good as the voltage and amperage contained within your battery. so start with a good battery before condemning a starter.

Aug 29, 2014 | 2004 Dodge Stratus

1 Answer

Starts but wont run


Some automobiles have a resistor in the coil circuit to reduce the voltage when the car is running. GM put it inside the starter solonoid for earlier cars. Chrysler put it on the firewall. When it goes bad the engine will start running when you crank it but it will die as soon as you release the key from the start position.

Aug 30, 2013 | Cars & Trucks

1 Answer

I have a 2003 nissan sentra spec-v it was working fine, i parked it, went to crank it a lil while later an it wouldnt start. ivechecked all the basics, starter, fuses and nothing. its almost like the...


MIGHT BE A RELAY ! LOCATED UNDER HOOD, YOU SHOULD SEE RELAY BOX NEXT TO BATTERY. MAKE SURE BATTERY TERMINALS ARE CLEANED, PUT SOME VASOLINE ON TERMINALS, RECONNECT, TIGHTEN. CHECK ALL GROUND WIRES. ARELAY BOX MAY ALSO BE LOCATED NEXT TO POWER STEERING . COULD HAVE A FAULTY SOLONOID@ STARTER, IGNITION SWITCH COULD ALSO BE FAULTY, ITS NEVER EASY TO PINPOINT ELECTRICAL PROBLEMS, PROCESS OF ALIMINATION, CHECK ALL STARTING CIRCUIT SYSTEMS, IS YOUR SHIFT LEVER ALL THE WAY IN PARK ? DOES ENGINE CRANK ? OR DEAD, NO POWER ? ARE YOU GETTING SPARK ? HOW ABOUT FUEL ? DID YOU REPLACE BOTH THE AIR &FUEL FILTERS ? THE STARTER / SOLONOID IS WHAT CRANKS THE ENGINE, I THINK YOUR PROBLEM IS THERE ! REPLACE RELAY TO STARTING SYSTEM, ARE YOUR SPARK PLUG WIRES NEW ! THEY WILL SHORT OUT ANY SPARK IF OLD, DIRTY, I SUGGEST A TUNEUP, NEW FILTERS, AND REPLACE STARTER/SOLONOID !!!!!!

Mar 16, 2013 | 2003 Nissan Sentra

1 Answer

HELP! i don't know why my car wont start!


YOUR STARTER & SOLONOID, ONE UNIT, MUST BE BAD ! WHEN YOU TURN KEY TO START THE BATTERY SHOULD ENERGIZE THE SOLONOID WHICH INGAGES THE STARTER INTO THE FLYWHEEL AND CRANKS THE ENGINE TO START. IF THIS DOESN'T HAPPEN, REPLACE THE UNIT !

Mar 14, 2013 | 1999 GMC Yukon

1 Answer

Engine wont start sometime. It will c Start to crank over, then it will stop. And only click the starter solanoid. I put a new starter switch and solonoid in. Problem still there. I think it has t do with...


If it just clicks when you try to start it then you need to check the battery and alternator. The anti-theft system wont even crank the solenoid.

Jun 02, 2010 | 2000 Ford Expedition

1 Answer

I have a 1996 chevy lumina. the motor wont turn


You need to check for power at the purple wire going to the solonoid while key is in the start position, if no juice then check starter relay-under hood- fuse ,and ignition switch

Feb 01, 2010 | 1996 Chevrolet Lumina Mini

1 Answer

Where is the starter solonoid located 04 aveo


You will need to verify if the starter solenoid is getting power when you are attempting to crank it. I dont have a diagram, but the clutch switch may be the problem if you must depress the clutch to start the engine.

Jan 16, 2010 | 2004 Chevrolet Aveo

2 Answers

95 jeep cherokee country 6 cyl auto. wont crank all the time


Bad solenoid i would guess. Not making a connection there. Any basic wiring and ignition switch problems should be alleviated by jumping the starter with a screwdriver. I would check the solenoid and starter brushes

Dec 30, 2009 | 1994 Jeep Cherokee Country

1 Answer

My 2002 chevy Blazer wont start but the battery is fully charged wont click or turn over


take a hammer and tap on the starter while someone tries to start it if it cranks put new brushes and bushings in it. also there is a small brass or copper bolt that goes to the solonoid. make sure it's tight and not croaded.

Jul 11, 2009 | Chevrolet Blazer Cars & Trucks

Not finding what you are looking for?
1993 Buick Park Avenue Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...