Question about 1983 Chevrolet Camaro

1 Answer

Were excactly is the vacum modulter located on a turbo 350 trany

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,674 Answers

Look on passenger side of transmission at the rear, and you should see a vacuum line going to it.

Posted on Jan 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why i put knew actuator on 99 escalade driver side and still will not work?


If you are talking about the 4x4 make sure the vacume hose to the actuater and the vacume switch on the trany is working properly it is located on the drivers side of the transfercase on the top with three vac lines comming from it.

May 04, 2014 | 1999 Cadillac Escalade

1 Answer

I have A 1977 chevy 4x4 350 engine 350 trany. Will not go in gear


at the base of the steering colum under the hood is a linkage rod that goes to a pivot point and then down to the trans did you knock that off climbing around? i guess you did let me know

Apr 25, 2012 | Chevrolet Cars & Trucks

1 Answer

Torque settings for turbo 2002 bora


all turbo have diafram and rad for adjusting air goes to engine this diafram control by vacum solenoid valve .accilerat up to 3000 RPM check rad if move .if not check vacum hose if no vacum check valve if ok .if the vacum ok check rad you can move in and out if no open turbo side and clean the valve . but you can't increase the power if you have problem with lack of power check air mass first

Jun 20, 2011 | Volkswagen Passat Cars & Trucks

1 Answer

1977 chevy with a turbo 350 slipping out of gear


Check the TV (throttle valve) cable, if that's out of adjustment the trany will think you want passing gear. Try disconnecting the cable at the carburator, that should make it shift into high gear at about 25 MPH and stay in high until you slow down. If it fails to stay in high gear then you have major problem. Are there a lot of miles on it? Are you sure you have enough fluid in it? Does the fluid smell burned. It might be just worn out. Good luck!

Apr 21, 2010 | Chevrolet Silverado Cars & Trucks

1 Answer

CHANGING A TRANY FROM 2 SPEED POWER GLIDE TO A 350 TURBO ON 63 NOVA NEW TRANY IS FATTER AND HAVING PROBLEMS WITH THE SHIFTER ITS THE ORIGINAL WHAT CAN I SO TO SLOVE THIS


You will have to cut into the transmission hump until you have enough room to fit your new transmission and get the shift linkage in place. Then you can rebuild around the new setup. It might be easier to get a new hump from a later model car that came with a 350 or 400 transmission and replace your old one with that. Hope this helps.

Sep 29, 2009 | 1985 Chevrolet Nova

1 Answer

86 s10 wit a turbo 700 trany


It sounds like the front pump had gone bad and you don't have any transmission line pressure from the pump. A long story short, your going to have to get the transmission rebuilt at this point. Good luck and hope this helps, keep me posted. 

Jul 16, 2009 | 1987 Chevrolet S-10 Pickup

2 Answers

Brakes


sense its a deisel i would go with the vacume pump, diesels don't put out any or very little vacume, if you don't have vacume than booster won't work hense hard peddel. when you say you let up on peddel and hit it again you got better break tells me it is not getting enought vacume to booster. i would go for the vacume pump.

Feb 02, 2009 | 1993 Ford F250

1 Answer

Tranny goes in reverse but wont go into foward gears


how many miles on trans? does fluid smell burnt?350 turbos are good tranneys but they do go bad. in my experance its reverse that goes out first on thies transmissions but thats not saying that it does not happen the other way either. my best guess is you need a rebuild. when you say it tries to move in forward gear that tells me that the clutches are shot. 350 turbos are worth rebuilding. its up to you.

Jan 07, 2009 | 1991 Nissan Sentra 2 Door

2 Answers

1999 f 350 diesel fuel filter location


under the cover that says 7.3 turbo. 2 nuts hold cover on and filter ins located under that cover

Jan 06, 2009 | 1999 Ford F350 Regular Cab

1 Answer

Chevrolet automatic transmission turbo 350


Was this a preexisting problem if not verify that the trani fluid type was correct. It should have been dexron or Dexron 2 fluid(not mercon products) check the fluid level over filling can be just as bad as underfilling)

Jul 13, 2008 | 1972 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...