Question about Saturn LS

1 Answer

Gas gauge stays on empty all the time.How do i fix it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Saturn Master
  • 1,564 Answers

You'll first want to check the connection to the fuel tank harness. This is the easy solution. Next you'll need to test the ground on the fuel tank itself. If these prove to be good, than your fuel sending unit has/ or is, failing. Thank you, Dana P.S. You may also want to wiggle the harness connector near your fuel guage from behind for these have been known to lose contact.

Posted on Jan 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I fix a fuel gauge that stays on empty?


The little gauge is controlled by a little motor inside the cluster and is going bad take off the cluster and replaced like 10 or 20 on ebay

Feb 19, 2015 | 2004 Chevrolet Malibu

1 Answer

Why fuel gauge not working gas guage on 2009 santa fe stays on empty even with a full tank of gas. Guage fluctuates from empty to 3/4 full to empty to 1/3 full at any given time.


It could be the sending unit in the tank or the gauge on the dash. A mechanic would test the signal coming from the sending unit to verify.

Jan 19, 2014 | 2009 Hyundai Santa Fe

1 Answer

How can I get my gas gauge to work


There is a "balance" ball/gauge inside the gas tank.. Many times it gets stuck. If it is stuck, try to SHAKE THEentire car from the bumper while u r pumping gas... However, many times the "gauge ball" brakes and u have to drop the fuel tank:(

May 14, 2013 | Cars & Trucks

1 Answer

GAS GAUGE SHOWS EMPTY AND THE WARNING LIGHT IS ON


I suspect either the sensor was not reconnected (or may have been damaged) when you put eveything back together or the float has sunk. Either way, you will have to do the job over to fix it.

Thanks for your interest in FixYa.com

Jan 27, 2010 | 1992 Volvo 740

1 Answer

2003 Impala fuel gauge used to bounce and now stays at full. When tank is empty, gauge shows 1/2-3/4 full. How to fix?


most of the time this is simply just the float in the gas tank getting stuck had the same problem in my car. unfortunately you have to access the gas tank to fix, but it is an easy fix. hope this helps any questions let me know.

Jan 25, 2010 | 2003 Chevrolet Impala

1 Answer

Gas gauge stays on full


very common. The sender in the gas tank is the problem.
It will need to be replaced some day
Both my gas tanks do the same thing in my F250. 1 tank stays full all the time and the other drops from full to about a half tank when I get to half a tank and then works so so till empty.

Dec 22, 2009 | 1992 Pontiac Firebird

2 Answers

Even with a full tank my 2005 Envoy XUV fuel light stays on and fuel gauge marks empty


u need to change this gauge or try to dissasseble and clean it very well then try to install it back again

Jun 06, 2009 | 2005 GMC Envoy Xl

2 Answers

Seccurity light staying on car starts and shuts right off gas gauge shows empty


Hello You can try resetting the security system by turning the key on and leaving it in the run position for 15 to 20 minutes, and then just start the truck don't turn to the off position until you have started the truck. after that all should be fine, And remember use the key with the chip on it too. Hope that gets you up and running. Thanks for using Fix Ya bear001

Jul 17, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...