Question about 2006 Hyundai Sonata

1 Answer

Does the engine come out the to or the bottom.when

Does the engine come out the top or the bottom.when removing for overhaul

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Hyundai Master
  • 2,030 Answers

You can do it either way.

Posted on Jan 30, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Red light is shown written engine oil level, stop engine

If you have oil especially liquid out the exhaust chances are the motor needs a rebuild. It would likely need top and bottom overhaul. Warning light comes on usually when less than 1L of oil left for a normal engine. Yes there are sometimes other causes of oil loss like faulty breathers but without knowing car specifics or history hard to further comment.

Jan 10, 2013 | Cars & Trucks

1 Answer

I need rotax 912 engine overhaul manual

Did you get the Rotax 912S overhaul manual?

May 07, 2012 | Cars & Trucks

1 Answer


call a local machine shop who rebuilds engines. most don't mind looking them up 4 u

Feb 26, 2011 | Ford F-250 Cars & Trucks

1 Answer

Hi.. i have a 1993 mits lancer with a 4G15 engine(EFI),. my problem is iam always adding oil to the engine, it emits white smoke in my tailpipe, my sparkplug is always wet with oil, and recently oil is...

Your engine has an issue, on the cylinder with the wet spark plug, that is resulting in motor oil getting into the combustion chamber. The two main causes are a broken piston ring or worn valve guides/damaged valve guide seal. The former is a bigger issue as the pistons have to be removed to replace piston rings, which is a major undertaking and often reguires engine removal. The valve issue is significantly easier, which can be cured by what is called a "top overhaul". However, even a top overhaul is beyond the scope of a casual DIY pundit.

Nov 11, 2017 | Mitsubishi Lancer Cars & Trucks

1 Answer

Driving my bmw e39 535i temp all fine accelerated up hill blew radiator top hose off and removed radiator to find bottom of rad also expanded now put another rad in but after 2 mins of running top hose is...

your cars radiator hose is building excessive pressure because the coolant / water could not circulate freely on your cooling system thats why its overheating, try removing the thermostat valve first and observe if it makes a difference, if problem is the same it could be the water pump is the culprit. try eliminating the easy things and less expensive approach first before deciding to top overhaul the engine of your car. a broken head gasket is not enough reason wont blow off your top radiator hose.

Apr 06, 2010 | 1998 BMW 5 Series

3 Answers

Engine suddenly started smoking through exhaust, raw diesel in exhaust and diesel in oil. isuzu trooper 1999 3.0

Hello. This is not good. Hate to say it but you will need to check for compression on all cylinders as it sounds like you may have a bad head gasket. Joe

Mar 18, 2010 | 1999 Isuzu Trooper

1 Answer


Register Yourself and your vehicle on Once you are registered one of the tabs at the top of the page will be "repair info". There they will have the complete repair manual for your car including the engine and engine overhaul section which will cover the radiator.

Dec 23, 2009 | 2002 Honda Civic

1 Answer

Considering buying a 94 volvo 940 gl

Hello, it sounds as if the person had an issue with the head. There is no mention of pistons, rings, connecting rod bearings, engine main bearings, oil pump. These are parts to an engine overhaul. It sounds as if they had maybe a timing belt to break and may have bent valves or either the bolt that broke off required them to pull the head off the engine to have bolt drilled out. Please rate my answer, Thank you.

Apr 06, 2009 | 1994 Volvo 940

Not finding what you are looking for?
2006 Hyundai Sonata Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides