Question about 1994 Chevrolet C/K 3500

1 Answer

Motor stalls when you shift out of park - 1994 Chevrolet C/K 3500

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 88 Answers

Could be a bad torque converter in transmission as this is a common problem with early model g.m. transmissions.

Posted on Jan 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After ideling a while i try to shift into reverse or to drive and it always dies .......any tips or ideas?


engine dies when shifting into reverse or drive - Third Generation ...

www.thirdgen.org/forums/tbi/346079-engine-dies-when-shifting.html
Feb 11, 2006 - engine dies when shifting into reverse or drive ... After it dies it starts right up and idles fine in park or neutral. ... these ignition items because you weretrying to cure the stalling, or, did the stalling occur after you replaced these items? ...The only thing that kept the car running was adjusting the Idle screw up.

Engine Dies When Placed In Gear***Split from Spittybug...EFI ...

dmctalk.org > ... > MAIN FORUMS > Custom DeLoreans/Mods > EFI

Jul 5, 2012 - 18 posts - ‎4 authors
Just to give an update on my car - I've been having an issue with the car stalling when moving from Park into Reverse or Drive (I have automatic). ... I have been playing with the idle advance trying to get more ... I put in the remainder of the AT fluid I had on hand and the car never died on shifting after that.

starts but dies when shifted into drive or reverse - Suzuki Forum


Jan 26, 2016 | Cars & Trucks

1 Answer

2000 tundra runs in park but stalls in drive


ok,
cel light on running?
scan it.
no engine power. (low fuel pressure, filthy maf? )

Feb 15, 2014 | Toyota Tundra Cars & Trucks

1 Answer

My car is cut off complete when i drive, but in "P"parking is no problem, what can be?


To answer your question I must put this in two parts , Firstly if the idle is low and you shift from park to drive and the engine stalls this is due to the idle being too low. When you shift from park to drive the transmission puts extra load on the engine causing it to idle lower and thus can stall. Remedy to fix is to either screw up idle adjuster but most times it's because of built up carbon in the intake throttle body causing the accelerator flap inside to not fully close . This causes the throttle positioning switch mounted on the side of the throttle body to send the wrong signal back to the computer saying that the car is not at idling position when it is. Remedy to fix this is to spray in some Carby Clean into the throttle body and then some more while the car is running, all while holding revs up on motor so it will not stall ( use the whole can ).
Now the second part is that you can have a bad wiring problem with either a broken wire or bad connector . When you put the car into Drive from the park position the engine will rock ( this is on all front wheel drive vehicles ) If you have a broken wire or bad connector some where between the motor and cars wiring loom by the engine moving it can open circuit any connection that controls engine running . Remedy to fix is to put the car into park and physically move and jiggle wiring in engine bay until symptoms occurs , then it's up to you to repair the fault

Feb 27, 2011 | 2000 Daewoo Lanos

1 Answer

The gear shift on my 1998 Lincoln Navigator is difficult to move out of park. It started about a month ago, when I tried to back out of my parking spot at home. Tonight, the vehicle died on me at a stop...


It can be either the shift cable or the Automatic parking brake release.
With your vehicle stalling it sounds like the parking brake release is leaking vacuum and causing stalling.

You can check with Autozone or Oreillys to see if there is an aftermarket part for that. Then locate the Auot release on your vehicle and when you take it off, slide the parts within the fixture to verify sticking.

Oct 12, 2009 | 2004 Lincoln Navigator

1 Answer

89 z24 stalls instantly when shifting out of park


Your lockup torque converter is bad I believe. When you shift from Park into any gear it will die.

Sep 17, 2009 | 1989 Chevrolet Cavalier

1 Answer

1991 Dodge Dakota dies when shifting from park


If it runs down highway fine, but just stalls when off throttle, turning, heater on, etc., I'd pull I.A.C. motor off and clean with throttle body cleaner & retry it. Clean port it came out of at same time too. if it cures it even temporarily, and does it again, replace IAC motor.

Apr 07, 2009 | 1991 Dodge Dakota

1 Answer

Car stalls after shifting into drive


ya need to have the code pulled,but sounds like a bad throttle position sensor

Mar 16, 2009 | 1996 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...