My seat alhambra is letting water in but cant find the leak

cigarette lights are held in by the outside case being screwed up from the back. pull the earth wire of the case and undo it

Camshaft setting tool put in position(rocker cover off) pump locking tool inserted, top dead center mark on flywheel in correct position.if not correct something won't line up

well if your pedal went to the floor. that means you blew the line or you lost the fluid. either way you will need to figure out what is leaking and then replace the part. if you got fluid in the res. then the master could be bad

-Check in its manual.


Good Luck

mai

either a new radio or try to pull it out and free it up with a thin screwdriver ? who knows as it could be damaged completely behind the facia

The most likely cause is a worn bore and the oil is leaking past the rings. It is possible that the oil is entering the combustion chamber through a breather.

cable on accelerator is lose or not connected

You do not have the air bled out or the slave is also defective, suggest you replace the slave then try again using a vacuum clutch bleeding tool like the one make by a company called MITYVAC

We do not have this make in the USA and have no manuals of any kind for it here at Fixya. Sorry.

the water can travel along surfaces or beams in the car so you cannot tell where it is actually leaking. in my ford windstar water leaked in right over the fuse box. it ran along a cross beam from the passenger side. if it has those plastic strips they use to go in between small gaps in the metal... like along the roof where the roof is and the metal of the sides joins it is likely they are leaking. best to take a garden hose and have someone inside the car with a flashlight on the floor looking for leaks