If you do your plugs and wires yourself, pull the coil packs out for a much much MUCH simpler and less painful procedure.
Change the spark plugs, plug wires, air filter, oil, oil filter, check transmission fluid, change trans fluid and filter if fluid is dirty or burnt smelling.
also, I'm not entirely sure about this but if you have a fuel filter that is accessible then check / change that as well.
if the vehicle is running hot then you might want to get the radiator flushed.
hope this helps, good luck and have a good day.
(any good auto parts store will be able to help you with parts and supplies.)
SOURCE: how do you reset power sliding door on 2000 chevy venture
there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man
SOURCE: rear brakes scrubbing on 1998 chevy venture van
Removal Procedure
Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from
being pinched between spring and shoe web or spring and backing plate.
Installation Procedure
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the
park brake actuator (3), and the adjuster actuator (1) properly.
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
SOURCE: Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
SOURCE: jump start 2000 venture
In order to reach the negative terminal to the battery in a 2000 Vebture (I have one) you must first remove the fuse housing. The fuse housing is a large black box that sits atop the battery. There os a single bolt that holds it in place located in fron of the battery bolted into the lip of the motor bay. Unscrew this, then unhook the fuse housing from the cross bar running from the back roght to the front of the motor bay. This is a tight fit so watch your knuckles. Once the fuse housing is out, the negative terminal is located on the backside of the battery. It is a tight squeeze black is negative, red is positive.
SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?
passengers side under the hood.....by the firewall.....
1,199 views
Usually answered in minutes!
×