2006 explorer. whencar put in reverse it won't move, when it does, it will jump and make a loud clanking sound

PLEASE HELP! SOS! car starts but doesnt move! - Club3G Forum ...

www.club3g.com > ... > Performance & Tech Forums > Problem Reports

Nov 16, 2010 - 61 posts - ‎14 authors
now yes, i will take the transmission is fubar into consideration but theres an .....however... idk about my cv joint, my car ONLY would make a loud ping noise when i move from a stop or brake ..... almost always when i put it into reverse. such as an engine mount sound, ... Vehicle: 2004 Eclipse Spyder GT. Loud knocking sound after oil change..
14 posts
Sep 20, 2010
Horrible noise upon start when cold
21 posts
Dec 24, 2009
Sporty knocking.. Oh noez!!one!!1!
16 posts
Mar 22, 2006
More results from www.club3g.com

Loud thump when I shift into drive or reverse - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusDec 19, 2012 - And while driving loud thump when car motor shifts th... ... Bad throttle position sensor can trip both lights and make the transmission shift at high rpms and shift hard even under light acceleration. .... the transmission will shift hard when firstput into reverse or drive ... 2004 Chevrolet Cavalier LS For Sale.Missing: mitsubishi ‎eclipse

Mitsubishi Transmissions & Drivetrains Repair Questions ...

if it is a 4 wheel drive sounds like your rear axle may have been cooked do to low fluid bad bearing or both check fluid level nad look for any kind of metal specs in fluid .

Cv axles normally click repetedly when moving ,doesn't sound like an axle,more like a motor mount or brake calpier .If you put your foot on the brake with the hood open ,put the truck in reverse and put a load on it and then in drive and load it you will be able to see the engine rock excessivly if a mount is bad.

Sounds like a bad Solenoid Shift Pack in the trans

Get your differential fluid checked and make sure you get synthetic for the rear if indicated. The clanking on turns reduces the possibility of the U-joints being the culprit. The driveshaft would give you noise going from reverse to drive, but in turns it is likely the clutches in the rear axle.

A four wheel drive can cause noise in all directions if the front drive has bad joints.

Does the shifter work okey and was this a one time thing? It my not have been in reverse. Is it okey now or does it always bang into reverse?

Hate to say it but it sounds like your looking at a new or rebuilt transmission. Get a diagnosis anyway, just to be sure I'm not jumping the gun.

sounds like you need a new clutch

Sounds more like a universal joint. Should be a inexpensive fix have it checked soon or you will need to add the price of a tow to the repair bill. part should not be over $30 each x 2 labor should not be much more than an hour.