Hi, I have a Mazda 6 that was fitted with a Park Pilot. It has recently stopped working.... just making a continuous beep when in reverse. I have cleaned the reverse sensors with no joy... can you supply me with fitting instructions at all so I can check all conections please? I read up how to use diagnostic mode but cant make out what the beep/light sequences mean!
Thanks, Justin.
SOURCE: My mazda error codes P0300 and P0302 what does this mean!!!
I would recommend joining on line the RX8 owners club which there is a vast knowledge bank and the people there will be able to steer you in the right direction. With what I have read on the forum it may be your coil packs as these have been common to fail. But beware failure of the coil packs can also damage your cat so may be worth an emmisions test as well. Hope this helps
SOURCE: mazda 6 reverse lights
ITS POSSIBLE THAT YOUR REVERSE LIGHT SWITCH IS FAULTY BEST WAY TO FIND OUT IS TO DISCONNECT REVERSE SWITCH AT G/BOX & BRIDGE OUT CONNECTIONS WITH IGN ON & IN REVERSE LIGHTS SHOULD GO ON IF THEY DO THEN ITS YOUR SWITCH.
SOURCE: 03 Mazda 6: Check engine light on, code po174
The oil pressure sensor does not have much to do with the P0174 code so the leak on the gasket is not the cause, usually it is the air mass sensor, or the intake sensor. if you have a leak of oil, this might as well mean that whoever changed the oil did not put the right specs of it and this caused the oil to get through. After some time you will experience that the rpms will reach only certain level and won't go higher. Change oil to the right specs and get the sensor cleaned if not to late or replaced (will be expensive). Gasket change wil be needed as well.
SOURCE: 2001 mazda protege keeps stalling
my 2001 mazda protege starts hard, idles low and high at various times (never normal) and it acts as though its going to stall at all times. sparks and wires are changed no help, changed air filter no help. any idea on what to do?
SOURCE: 01 Mazda Millenia 2.5L check engine light
sounds like its a different sensor causing problem. could be TPS SENSOR OR MAP SENSOR .
71 views
Usually answered in minutes!
×