My brake lights n tail light wont come on at all i checked fuses replaced everything including the brake buttons and still wont work..wats next

Are the front park lights operational? These are tied into the tail lights as well. If the front park lights are operational and the rear are not, suspect bad/burned out bulbs. If no park lights operational, suspect fuse or wiring

the brake switch sends power to the turn signal switch and then on to the bulbs. Brake lights are on a separate fuse. Check both areas for the problem

replace brake light switch @ BRAKE PEDAL, next, replace turnsignal flasher under dash, check for blown fuse, if turn sig. still doesn't work, check turnsig., switch, & or for loose connection.

pull your brake light assmb out and check your connections including ground

COULD HAVE FAULTY BRAKE LIGHT SWITCH OR BAD GROUND WIRE AT BRAKE LIGHTS AND TURN SIGNAL LIGHTS.

Check fuses, I believe that the WJ's (99-04) ran a separate circuit for bake lights. Not sure if they did same for the ZJ's (93-98)

Replace bulbs, clean sockets, check towing harness, check brake swich under brake pedal. fuses???
Vitally

Well Jennifer, it sounds like you've done all the things that I'd have done. Try for a bad ground next. Do the lights in the dash cluster work? They're wired together with the tail-lights (so that you know if the rears go out). There should be a ground wire somewhere connecting the body to the engine or chassis.Look around the rear of the engine bay. Good Luck.

most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine

Solution to your problem ... 1- I purchased from 1aauto.com a pair of Circuit Boards for my Chevy Venture 2003 for 85.00 $ ..free shipping 2 - I Installed them both , all lights now were not working at all. So I checked them and they were all burned ...So I purchased new ones ....Everything was working fine now but now my signal lights were not working left and right .....Checked the fuse box next to the passenger side door .... It was burned . Changed the fuse / Signals are working fine now ....All is good I just did this yesterday evening August 12, 2008 Conclusion ..Change everything going forward so you do not need to run around like I did from one store to another!

1. Circuit Board : New
2. Bulbs : New
3. Fuses : New

Thank you