Engine temperature goes up high and doesnt always blow warm air

heater blows cold air idle chrysler 300 Questions & Answers ...

www.fixya.com > Forum > Tags

Find solutions to your heater blows cold air idle chrysler 300 question. ... blow warmair for a few mins then back to luke warm. i replaced thermostat ... HEAT BLOWSCOLD AIR WHEN IDLING ONLY GETS HOT WHEN START DRIVING ... About 15 minutes after driving the diver side vents start blowing straight cold air but the ...

Heater only works when pressing the gas? - DoItYourself.com ...

www.doityourself.com/...repairs.../459521-heater-only-works-when-pres...

Nov 3, 2011 - When I press the gas, the air from the vents is nice and hot. .... So am Idriving a car with a ton of problems, or could the power steering ... Just anotherquestion, when warmed up does the engine temperature ... When the heater is on and I'm not pressing the gas pedal, luke warm air blows from the vents.

Heater blows cool air when stopped and warm air while ...

https://www.reddit.com/.../heater_blows_cool_air_when_stopped_...

RedditFeb 12, 2014 - Heater blows cool air when stopped and warm air while driving 2008 Kia Spectra (self. ... just fine but appears to blow cool air when I was stopped at a stoplight. ... My temp gauge would also be pegged high when at idle / low RPM. ...thermostat only blocks coolant going to the radiator, and the heater core, ...Missing: 300m ‎luke

Why is My Car AC Blowing Hot Air? - BlueDevil Products

gobdp.com/blog/car-ac-blowing-hot-air/

Heater core may be clogged. Try flushing it to see if water flows through freely. Also check the heater water control valve for restrictions.

First things first.....You must have the air conditioning system hooked up to an a/c system machine and then checked for leaks and also read low and high side pressures. If there are leaks then low Freon (R134a) content and low refrigerant oil can cause the a/c system to not engage the a/c compressor which basically means you will not have proper defrost functionality nor regular air conditioning. Most shops, when working with your air conditioning, will install air conditioning dye to assist them in locating leaks and is the first step in diagnosing all a/c systems. Post the findings after thw

there might air in the system so you will have to bleed it or remove the rad cover and let the car run for a bit the should be on in full

Hello: First check and see if you are low on coolant, check both the overflow tank and the radiator itself. If low put antifreeze in it the check for leak. Have unit pressure checked

It sounds like your thermostat may be stuck open, with the engine working hard the temperature of the engine comes up thus the warm air, but just at an idle the thermostat is letting the coolant circulate and not holding it their until it reaches a warm enough temp. You are most likely going to need to change the thermostat.

start with a thermostat...

It may be the valve that controls the amount of water entering heating core but I'm wondering if your engine thermostat isn't stuck open. This is what controls the coolant temperature in your engine. It closes off while engine is off. It will remain closed after you start your car until the water warms to a certain temperature then it starts to open enough to keep your car at the proper operating temperature. If it stick open then it will take a lot longer for the engine to heat up and on smaller cars might never heat up enough for your heater. If you live in very cold climates such as where I live in Wyoming, we have to change to a higher degree thermostat so we have a good heater when it's 30 below zero.

Be very cautious here but one way you can check this is to put a piece of cardboard in front of your radiator and stop the airflow that cools your engine coolant. THIS WILL CAUSE YOUR CAR TO HEAT UP AND CAN CAUSE ENGINE DAMAGE IF IT OVERHEATS. Don't completely cover the radiator but if your heater warms up when you put the cardboard in front of radiator it's a good sign that your thermostat is stuck open and needs to be replaced.

First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced.
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is warm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest flushing the heater core.

the problem is the air temperture control door (known as a blend door) is stuck or the door's actuator is not working. your engine temp is correct and not the problem.