Left rear window regulator cable for manual crank window came off need how to put back on

Should be a 5 minute task at your nearest dealer. The clips will be genuine part only. Take your VIN number in with you.

You don't resting the cable you replace the window regulator. That siad there are no diagrams.

get the service and repair manual from the given link and get the solution easilyb http://toolsnyou.com/

window is off track or the regulator is bad, you will need to remove the panel and inspect the window and regulator, if it is the regulator you will see a loose cable. Good Luck Tim

- Door trim.
Removal
- Unclip decorative panel -2-.
- Remove decorative panel -2- toward front.
- Remove bolts -3- (3x) from door trim -1-.
For vehicles with electric window regulators
- Window regulator switch, removing and installing Page 70-25 .
For vehicles with manual window crank
- Manual window crank, removing and installing Page 70-26 .
For all vehicles
- Unclip door trim -1-. Replace damaged clips Fig. 3
- Raise door trim -1- upward approx. 20 cm. out from door shell.
- Disengage Bowden cable for interior door mechanism Fig. 1 .
- Disconnect electrical harness connectors Fig. 2

you cant fix cable, you need the Window Regulator

There is a nylon peg that holds the window to the regulator.You need to use a 1/8 in.pin punch to remove the peg.But you have to get the window up far enough where the peg lines up with the hole in the regulator.You will have to replace the regulator.If you put the cable back on it will just fall back off.Hope this helps.Good luck.

These cars have a window regulator that is made with a cable and a plastic wheel that the cable rolls around. Once it wears out you need to replace the whole regulator, it comes with new motor. Look on ebay, cheapest way to buy a new one. You can take off door panel and push window back up and wedge or vise grip so it wont fall back down.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door. Slide the retaining clip on the window crank to the side and the crank will pop off. Then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything.You'll need to disconnect the bolts holding the regulator to the frame and connecting the regulator to the base of the window (make sure you use wedges to hold the window up) and the regulator will slide out of the door.. reverse to put back

No the only way to fix these wire regulators is replace them, they are fairly cheap, think about it, you pull the door panel, remove the regulator try to fix it and put it back, right away it fouls up, you have worked hard for nothing, replace it.